User manual

PB16

Configuring the WRE/AP

3. Place your secondary WRE/AP within range of your Wireless Router

and near the area where you want to extend the range or add the

network segment. Typically, your indoor range should be between 50

and 150 feet.

4. Connect power to your WRE/AP. Ensure that it is powered ON and

prceed to the next step.

5. From a computer already connected to your network, access the

Wireless Router’s advanced setup utility by opening your browser.

In the address bar, type in “192.168.2.1” (do not type in “www” or

“http://” before the number).

Note: If you have changed your WRE/AP’s IP address, use that IP address.

6. To make any changes to the Wireless Router’s settings, you have to

page takes you to the login screen.

7. You will see the Wireless Router’s user interface in the browser

window. Click “Wireless Bridge” (2) on the left-hand side of the

screen. You will see the following screen.

8. Check the box that says “Enable ONLY specific Access Points to

connect.” (1)

9. In the field named AP1 (3), type in the WLAN MAC address of your

WRE/AP. When you have typed in the address, click “Apply Changes”.

10. Wireless Bridging is now set up.

(1)

(2)

(3)