User manual

1
2
3
4
5
6
7
section
1313
13
Configuring the WRE/AP
Configuring as a Wireless Access Point
The WRE/AP can add wireless-enabled computers to an existing wired
network. The Access Point acts as a bridge between your existing wired
network and your wireless-equipped computers. Please be sure to follow
the steps below carefully.
1. Select a suitable place for your WRE/AP.
2. Connect an Ethernet cable between the WRE/AP and your cable/DSL
router’s LAN port, Ethernet switch, or hub.
Router, Ethernet
switch, or hub
Wireless Range
Extender/Access Point
3. Connect the power supply to the WRE/AP by plugging the round
DC connector into the DC jack on the WRE/AP. Plug the power
supply into the wall. Verify that the Power LED and the Link LED are
illuminated. If both LEDs are illuminated, the WRE/AP is connected
properly.
4. Place the WRE/AP on a desktop or mount it to a wall in the location
that you have chosen. Next, swivel the antennas so they are both
pointing up.
Connection and placement of your Wireless Access Point is now
complete!