User manual

1
2
3
4
5
6
7
section
1111
11
Configuring the WRE/AP
3. To enter the WRE/AP’s Mac address into the router, do the following:
From a computer already connected to your network, access the
Wireless Router’s advanced Setup Utility by opening your browser.
In the address bar, type in “192.168.2.1” (do not type in “www” or
“http://” before the number).
Belkin Wireless
G Router
Secondary WRE/AP MAC Address
Wireless G Range
Extender/Access Point
: :
:: : : : : : : :
NOTE: If you have changed your WRE/AP’s IP address, use that IP
address.
4. To make any changes to the Wireless Router’s settings, you have to
log in. Clicking the “Login” button or clicking on any one of the links
on the home page will take you to the login screen.
5. You will see the Wireless Router’s user interface in the browser
window. Click “Wireless Bridge” (1) on the left-hand side of the
screen. You will see the screen below.
6. Check the box that says “Enable ONLY specific Access Points to
connect” (2).