User manual

Start of Tx

This sets the character that will be sent prior to sending data in the selected file.

The most common character used is the percent, %. Choose a setting as specified

in the CNC manual. If your file already contains a % at the beginning, set to none

so duplicate % signs are not sent.

The following choices are available:

null char

none

Use the null character for controls the need an ASCII char 0 to be used as the start

character.

End of Tx

This function sets the character that will be sent after sending data in the selected

file. The most common character used is the percent, %. Choose the setting as

specified by the CNC manual.

The following choices are available:

null char

none

Use the null character for controls the need an ASCII char 0 to be used as the end

character.

Probe RS-232

This function shows the current RS-232 levels present. This can be used to help

diagnosis serial issues.

Start Rx

This sets how the LANCNC will initiate receiving a file. Some machines require

an initial XON to begin the transmission. Most machines do not, so the

‘automatic’ setting will work for most machines.

- 9 -