User manual

Main Menu

The following is the main menu displayed upon application of power. The outer round

buttons are used to adjust the item to be selected either up or down. The center button is

used to select the function that is highlighted with the > < symbols. The descriptions of

each function are described later in the manual.

CNC to File Menu Selection

With this selection, CNC data can be sent directly to the local ftp server memory. The file

name used to transmit CNC data is generated automatically*. If a different name file

name is desired, select ‘Dir’. ‘Dir’ will display the directory. A different file name can

be typed in by selecting [type File].

Shown in the above screen display, the file name CNC16.TXT has been automatically

generated by the LANCNC control. Press the button under the Start option to prepare

the ftp server memory storage to receive a file from the CNC. Press the button under the

Cancel option to return to the main menu without creating a file. Once the “Start” has

been pressed, a file send operation (punch) from the CNC should be initiated.

*More about the Automatic File Name Selection: All files saved to the ftp server memory

storage use a file name with the following structure: CNC####.TXT. The number will be

the next number in the sequence of the files found on the ftp server. If the largest

sequence numbered file name number found is CNC15.TXT, then the next file name

created will be CNC16.TXT.

- 3 -

Select:>CNC to File<

File to CNC

DNC

v3.92 SETUP

to file:

CNC16.TXT

Dir Start Cancel