User manual

Use the following step-by-step procedure to setup the router and then the access point.

These settings are based on using a Belkin Wireless G router and access point:

Router Configuration

1. Open a Web Browser

2. In the address bar type http://192.168.2.1

3. Click on Wireless Bridge in the left hand column under Wireless

4. Enter your password if any and click Submit

5. Check the box that says Enable Wireless Bridging, click Apply Changes.

6. Click Home, note the WLAN MAC address under LAN settings

Access Point Configuration.

1. Open a Web Browser

2. In the address bar type http://192.168.2.254

3. Click on Wireless Bridge in the left hand column under Wireless

4. Enter your password if any and click Submit

5. Check the box that says, Enable Wireless Bridging

6. Check the box that says, Enable ONLY specific Access Points to connect and

enter the WLAN MAC address from the router, click Apply Changes.

Note: The channel must be identical on both the router and the access point.

It is important that the router and access point use the same Channel, SSID, and security

settings. The access point will become another device on the routers network. When

both devices are using the same wireless communication parameters, they will be able to

communicate with each other.

Changing the IP address on the LANCNC device

The LANCNC defaults to IP address 192.168.2.111. If a different IP address is desired,

use a PC to create a text file on SD card with the file name LANCNC.INI in the root

directory. This file must be text only and have carriage returns at end of each line.

To change the IP address of the LANCNC to 101, the contents of the LANCNC.INI file

should look like this:

IP address=192.168.2.101

IP mask=255.255.255.0

IP gateway=0.0.0.0

IP dns=0.0.0.0

Remember the last number on the IP address will be that CNC’s “number.” To access

the files on that CNC’s LANCNC file server, type in “ftp:192.168.2.101” in a web

browser to view the directory contents stored on the machines 1GB SD card.

Revision History:

Rev 3.92 Initial release

- 19 -