User manual

Different types of SD cards can be used. SD/MMC cards can be used up to 2GB and

SDHC cards up to 8GB.

Creating Sub-directories

Directories cannot be created directly using an FTP protocol. In order to create directories

on the SD card, create the directory first on the PC and then copy and paste the directory

onto the LANCNC FTP. An alternative is to create directories directly onto the SD card.

Remove the SD card from the LANCNC and insert it into a PC to create the directories.

Navigating the Menus

There are three buttons on the panel of the LANCNC-RMT device. Two square buttons

bracket a round button in the center. The square round buttons are used to control the

cursor in order to highlight options from a menu or file selection. The cursor is typically

shown bracketing items with > and < symbols. The center button typically selects the

options or files highlighted with the > and < symbols.

Main Menu

The following menu indicates what the main menu will display upon application of

power. The outer round buttons are used to adjust the item to be selected either up or

down. The center button is used to select the function that is highlighted with the > <

symbols. The descriptions of each function are described later in the manual.

CNC to File Menu Selection

With this selection, CNC data can be sent directly to the local ftp server memory. The file

name used to transmit CNC data is generated automatically*. If a different name file

name is desired, select ‘Dir’. ‘Dir’ will display the directory. A different file name can

be typed in by selecting [type File].

As shown above, the file name CNC16.TXT has been automatically generated by the

LANCNC-RMT control. Press the button under the Start option to prepare the ftp server

memory storage to receive a file from the CNC. Press the button under the Cancel option

to return to the main menu without creating a file. Once the “Start” has been pressed, a

file send operation (punch) from the CNC should be initiated.

- 4 -

Select:>CNC to File<

File to CNC

DNC

v5.06 Next Menu

to file:

CNC16.TXT

Dir Start Cancel