User manual

4. Select “Internet Protocol (TCP/IP)” so that it is highlighted and click the

“Properties” button.

A new screen will pop up. Select the button “Use the following IP address:” and type in

an address of 192.168.2.101. The sub-net mask should be 255.255.255.0. Click “OK”.

The “Local Area Connection Properties” menu will be displayed. Click “Close”. There

will be a slight delay while your PC applies these new settings.

Figure 4

5. You may exit from the Control Panel. Start Internet Explorer and type

ftp://192.168.2.111 in the address bar. A screen similar to the one shown in Figure

5 should appear. A number of files are loaded on the SD card when shipped for

testing purposes. A message will appear “To view this FTP site in Windows

Explorer, click Page, and then click Open FTP Site in Windows Explorer”.

- 16 -