User manual

SERVER.INI File Parameters

The SERVER.INI file contains the parameters used by the LANCNC to configure the

available access to the oeprator. Names of FTP servers can be added or removed to tailor

the LANCNC-RMT for each machine. Type the parameter names exactly as shown

below. Use all capital letters without spaces. Finish each parameter line with a carriage

return by pressing the enter key in the editor used.

SD=NO

If this parameter is inclueded, it will disable access to the SD card. The SD card is still

required for normal operation of the LANCNC-RMT, however, disabling access to the

SD card will prevent the user from viewing and saving copies of NC files onto the SD

card. A remote server will be required for the LANCNC-RMT to access NC files.

NAME=

Enter a name for the server. All the parameters after the name will be attributed to this

server name. This name will appear when viewing the directory. Keeping the name to

less than 15 characters will ensure it is displayed correctly.

IP=

Enter the IP of the server named before it. The IP should be the static IP address that the

server uses.

PORT=

Use PORT=21 for most uses unless it is not actually port 21. This parameter will go with

the server named before it.

USER=

If the FTP server requires a user name, enter it immediately after the equal sign.

PASSWORD=

If the FTP server requires a password, enter it immediately after the equal sign.

START DIR=

If the FTP server has many directories, the starting directory name can be entered after

the equal sign. When the operator accesses the FTP server, it will first display this

directory first. It will limit access to directories and files within this directory.

- 12 -