User manual

Start of Tx

This sets the character that will be sent prior to sending data in the selected file. The most

common character used is the percent, %. Choose a setting as specified in the CNC

manual. If the character is already in the NC files then select “none” so the character is

not sent twice.

The following choices are available:

null char

none

Use the null character for controls the need an ASCII char 0 to be used as the start

character.

End of Tx

This function sets the character sent after sending data in the file. The most common

character used is the percent, %. Choose the setting as specified by the CNC manual. If

the character is already in the NC files, select “none” so the character is not sent twice.

The following choices are available:

null char

none

EOT (ASCII 4)

Use the null character for controls the need an ASCII char 0 to be used as the end

character.

Start Rx

This sets how the LANCNC will initiate receiving a file. Some machines require an

initial XON to begin the transmission. Most machines do not, so the ‘automatic’ setting

will work for most machines.

Help

This will display basic help menus describing the uses of the menu items. Also, the

network addresses will be displayed at the end of the help pages. Copyright infromation

for the product is also displayed.

- 10 -