User manual

14
Usage
(continued)
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on the MASTER unit only,
and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKS (if there are slave units present) and then
puts the unit in AutoScan mode. If the unit is a single MASTER unit, pressing the button immediately invokes
AutoScan mode. This is evident by a long BEEP, followed by two short beeps.
SCAN TIME:
Amount of time the OmniView
™
MATRIX stays on
one port before switching to the next port when in
Scan Mode
DISPLAY TIME:
Amount of time the OSD Menu or Port Name remains
displayed on-screen after making a port selection
[↕]: SELECT
(INS): RENAME
(Enter):COMPLETE
(Esc): Exit
SCAN TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
DISPLAY TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
Erasing all the OSD names stored in memory.
You can delete all the OSD names stored in memory, and change them back to the factory default (“Channel 1,”
“Channel 2,”) etc. names by pressing [scroll lock] [scroll lock] [DELETE]. You must wait 30 seconds for the memory to
be reinitialized.
F1D208-OSD_EU_man.qxd 4/20/00 4:37 PM Page 14