User manual

INSTALLATION

Step-by-Step Installation Guide

This section provides complete instructions for the hardware setup of

a single SOHO Series KVM Switch. (F1DS102P, F1DS104P,

F1DS102T, or F1DS104T)

Important Note:

Before attempting to connect anything to the SOHO Series KVM

Switch or into your computer(s), make sure that everything is

powered off. Plugging and unplugging cables while computers are

powered on may cause irreversible damage to the computers and

KVM Switch. Belkin Components will not be responsible for damage

caused by these actions.

Installing the SOHO Series KVM Base:

Hold the main housing with one hand and the base with the other.

With the narrow part of the base facing towards the rear of the

housing, align the hooks of the base to the base holes located

underneath the housing. Put the hooks through the holes and push

the base toward the front of the housing to lock the base into place.

See fig. 3.

fig. 3