User manual

14
Usage (continued)
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on
the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKS (if there are slave
units present) and then puts the unit in AutoScan mode. If the unit is a single MASTER unit,
pressing the button immediately invokes AutoScan mode. This is evident by a long BEEP,
followed by two short beeps.
SCAN TIME:
Amount of time the OmniView
™
PRO stays
on one port before switching to the next
port when in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection.
[↕]: SELECT
(INS): RENAME
(Enter):COMPLETE
(Esc): Exit
SCAN TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
DISPLAY TIME:
■ 7sec ■ 15sec ■ 30sec ■ 60sec
P73055/F1D108-OSD/EU/man.qxd 4/21/00 2:25 PM Page 14