Conserve Switch AV Surge Protector with Remote ™ User Guide
Now you can control power to your whole entertainment system with a single click. The wireless remote switch lets you shut off power—including standby power—to up to eight devices at once: your TV, DVD player, gaming console, and more. Two Always-On Outlets stay on for devices that need continuous power, like your DVR. Place the remote on a table or shelf, or mount it on the wall, for the convenient way to save energy.
Quick Setup Guide 1 Plug in any of your devices that do not require constant, roundthe-clock power into one of the Conserve Switch AV Surge Protector’s Remote-Switched Outlets. Recommended devices include: Computers Printers Televisions Video Game Consoles DVD Players Home Audio Systems . . . . . . 2 Plug in any of your devices that require constant, roundthe-clock power into one of the Conserve Switch AV Surge Protector’s Always-On Outlets.
indicator lights 4 Plug your Conserve Switch AV’s power cord into a wall outlet. 5 Remove the clear battery tab from the back of the remote switch. The remote is now ready to use. NOTE: Mounting screws are not included; see the “Wireless Remote Switch with Wall-Mount” section later in this user guide. . The “Always-On Outlets” light should be on if power is present. If this light goes out at any time, it means the circuit breaker has tripped and should be reset. .
How to Use Your Conserve Remote Switch 1 Firmly press and release the “I” button to turn ON the RemoteSwitched Outlets. As you press the button, a green light flashes on the remote switch to indicate that the remote is working. Your devices are now powered and ready for use. 2 Turn on and use your devices as usual. 3 When you are finished using your devices, turn off each device as you normally would.
Installation, Mounting AND Syncing Instructions 5 When ready to use your equipment again, repeat Steps 1–5. NOTE: A green LED on the wireless remote switch will illuminate when the switch is pressed. This indicates that the signal was sent and that the battery is OK. If you do not see the light, it is time to replace the battery. To replace the battery, see the Troubleshooting section.
product features .
Technical Specifications The manual override switch on the Surge Protector can also be used to turn the Remote-Switched Outlets on or off without the wireless remote switch in the event the remote is lost or the battery needs replacing. “Not Grounded” light is on. The “Not Grounded” light indicates you may have a ground-wiring problem in your home, and you should contact an electrician to properly ground the outlet.
for shipping charges for the Conserve Switch AV). Belkin reserves the right to discontinue any of its products without notice, and disclaims any limited warranty to repair or replace any such discontinued products. In the event that Belkin is unable to repair or replace the Conserve Switch AV (for example, because it has been discontinued), Belkin will offer either a refund or a credit toward the purchase of another product from Belkin.
estimate the cost to repair such equipment. The cost, if any, of shipping the equipment to and from such repair facility and of such estimate shall be borne solely by the purchaser. Damaged equipment must remain available for inspection until the claim is finalized. Whenever claims are settled, Belkin reserves the right to be subrogated under any existing insurance policies the claimant may have. as required by law.
Use Energy Wisely Using electricity or driving a car does have an effect on the environment, but by using energy wisely we can prevent waste and reduce carbon dioxide (CO2) emissions. Company Information Belkin Tech Support U.S. http://www.belkin.com/support For more information and to learn about other Belkin Conserve energy management products, please go to belkin.
