Operating instructions

DG834G Reference Manual
5-8 Protecting Your Network
v3.0, September 2005
• WAN Users
These settings determine which packets are covered by the rule, based on their source (WAN)
IP address. Select the desired option:
– Any — all IP addresses are covered by this rule.
– Address range — if this option is selected, you must enter the Start and Finish fields.
– Single address — enter the required address in the Start field.
•Log
You can select whether the traffic will be logged. The choices are:
– Never — no log entries will be made for this service.
– Always — any traffic for this service type will be logged.
– Match — traffic of this type which matches the parameters and action will be logged.
– Not match — traffic of this type which does not match the parameters and action will be
logged.