Operating instructions

DG834G Reference Manual
NETGEAR VPN Configuration C-15
v3.0, September 2005
Figure C-12: Addressing and subnet used for telecommuter example
Setting Up the Client-to-Gateway VPN Configuration
(Telecommuter Example)
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
• Step 1: Configuring the Client-to-Gateway VPN Tunnel on the VPN Router at the Employer’s
Main Office.
• Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC at the
Telecommuter’s Home Office configures the NETGEAR ProSafe VPN Client endpoint.
Table C-1. Configuration summary (telecommuter example)
VPN Consortium Scenario: Scenario 1
Type of VPN: PC/client-to-gateway, with client behind NAT router
Security Scheme: IKE with Preshared Secret/Key (not Certificate-based)
Date Tested: May 2005
Model/Firmware Tested:
Gateway DG834G firmware version v2.10.20
Client NETGEAR ProSafe VPN Client v10.5.1 (build 8)
IP Addressing:
Gateway Fully Qualified Domain Name (FQDN)
Client Dynamic
Gateway A
ntgr.dyndns.org
192.168.0.1/24
192.168.0.1
WAN IP
WAN IP
LAN IP
Client B
FQDN 0.0.0.0
Router
(at employer's
main office)
Telecommuter Example
NAT Router B
Router
(at telecommuter's
home office)
PC
(running NETGEAR
ProSafe VPN Client)
192.168.2.3
"fromDG834G.com"
"toDG834G.com"