User's Manual

3
❒ It is recommended that the AC power adapter be used at all times. Even though
this unit can be self powered, it is only for low speed devices and multiple
devices can cause a power shortage in the unit.
❒ It is recommended that the AC adapter to be used whenever more than one hub
is used in a stacking configuration.
❒ Do not remove the AC adapter when the unit is working.
3. Connecting
3.1 Connecting to your computer
This unit can be connected or disconnected to your PC when the computers on and
running programs, using any USB port on your computer. This product allows your
computer to interface with various USB devices. See figure below.
3.2 Connecting the USB cable
A type connector
Insert USB cable into the down stream port of the PC (or) this product. Make sure
that it goes all the way into the socket and is firmly connected.
Insert USB cable to up stream port of this product (or) USB devices. Make sure
that it does all the way into the socket and is firmly connected.
4. Initial Connection
❒ When connecting this unit for the first time a message box will display :
“Searching for unknown hardware device, searching software for installation”
❒ Your computer will then start up the Device Driver Wizard, and will install the
unit. This product is recognized as “generic USB Hub”
❒ Once your computer has confirmed installation, you can then connect any USB
devices you wish to the Hub.