Installation Instructions

Installation instructions

Important notes

If the appliance is being installed under a hob, refer to the

assembly instructions for the hob.

Do not use the door handle to carry or install the appliance.

Before installation, check the appliance for transportation

damage.

The appliance must be disconnected from the power supply

during all installation work.

Preparing the units - Fig. 1

■ The safe operation of this appliance can only be guaranteed if

it has been installed to a professional standard in accordance

with these installation instructions. The installer is liable for

damage incurred as a result of incorrect installation.

■ Fitted units must be heat-resistant up to 90 °C, and

neighbouring unit fronts up to 70 °C.

■ Cut-out work on the units and worktop should be performed

before fitting the appliances. Remove any shavings or the

function of the electrical components may be impaired.

■ Caution during installation. Parts that are accessible during

installation may have sharp edges. Wear protective gloves to

prevent cuts

■ The power socket for the appliance must either be located in

the hatched area B or else away from the installation space.

■ A gap of 5 mm is required between the appliance and

surrounding unit fronts.

■ Secure freestanding units to the wall using a standard bracket

Appliance under the worktop - Fig. 1

There must be a ventilation cut-out made in the intermediate

floor of the surround unit.

Secure the worktop to the fitted units.

If a fitted oven is to be built in under a hob, pay attention to the

hob installation instructions.

Appliance in a tall unit  Figs 2+4

The appliance may also be installed in a tall unit.

There must be a gap between the intermediate floors and the

mounting wall of approx. 20 mm in order to provide ventilation

to the oven.

Only fit the appliance at a height where removing baking trays

does not present a problem.

PLQ

PLQ



PLQ

