User manual

14 - Belinea 10 80 30
ENGLISH
TROUBLESHOOTING
Blank Screen
Power indicator is off
- Check if the power cable is connected properly (see section “Connecting”).
- Make sure that the monitor was turned on using the power switch (see section “Startup”).
Power indicator lights orange
- Perhaps a power saving mode is active?
Power indicator lights green
- A screen saver may have activated automatically after a certain period of inactivity. Press any key on your keyboard or
move the mouse.
RGB bars
- Make sure the signal cable is connected to the PC’s VGA connector (see section “Connecting”).
- Is the PC turned on (see section “Startup”)?
Display Problems
Image is displaced to the left/right or to the top/bottom
- If the image is displayed normally but not centered correctly, you can adjust its position using the OSD functions. For more
information on this topic consult the functions “V. Position” and “H. Position” in the “OSD Menu Functions” section.
Image flickers or is shaky
- If the image is displayed normally but appears slightly shaky, the vertical frequency might be too low. Select a higher
frequency. For more information on this topic consult the user’s guide of your PC, graphics card or operating system.
- Perhaps setup file chosen for the monitor is incorrect. For information on monitor setup under Windows 95/98/ME/2000/NT
consult the “Configuration” section.
Image is blurred
- Check brightness and contrast settings (see section “Basic Setup”).
- If the vertical frequency is too high, the image might be slightly blurred. In this case lower the frequency.
Color problems
- If the colors are distorted in some areas, you should demagnetize your monitor (see “Degauss” function in section “OSD
Menu Functions”).
- If the colors are off (e.g. white is not really displayed as white etc), you should adjust the color temperature (see “Color”
function in section “OSD Menu Functions”).
- Devices generating magnetic fields, such as laser printers and loudspeakers, shouldn’t be placed near the monitor since
they might affect image quality.
Image edges distorted
- If the image is slightly distorted, bent or tilted at the edges or the entire image is not aligned horizontally, you can correct
this using the OSD menu functions (see “Trapezoid”, “Parallel”, “Top/Bottom Corner” and “Rotation” functions in section
“OSD Menu Functions”).
TECHNICAL SPECIFICATIONS
Picture tube 21 inches diagonal size (50.8 cm visible),
dot pitch diagonal/horizontal: 0.25mm/0.20mm
glare-free coating; low emissions according to TCO '03, phosphorus type P22
Input signal RGB analog, 15-pin plug (D-SUB) and BNC
Display colors unlimited colors
Video Bandwidth 340 MHz
Synchronization 30 – 125 kHz horizontal, 50 – 160 Hz vertical
Resolution maximum resolution: 2048 × 1536, ergonomic resolution: 1600 × 1200 (85Hz)
Power supply 100 – 240V~, 50 – 60 Hz, 3.0 A
Power consumption ON status: max. 120 Watts; power indicator color: green;
SLEEP status: < 4 Watts; power indicator color: orange;
Power saving functions conforming with EPA
Dimensions, Weight width: 500mm, height: 495mm, depth: 486mm (monitor only), 25 kg (monitor only)
Environmental conditions Operation: 32 – 95 °F (0 – 35 °C), rel. humidity: 10 to 90% (non-condensing)
Storage: -13 – +140 °F (-25 – +60 °C), rel. humidity: 10 to 90% (non-condensing)