Product Overview

Technical data sheet AFX24-MFT-X1
www.belimo.com AFX24-MFT-X1 • en-us • 2020-12-16 • Subject to change 2 / 2
Ambient humidity max. 95% r.H., non-condensing
Servicing maintenance-free
Weight
Weight 4.6lb [2.1kg]
Materials
Housing material Galvanized steel and plastic housing
Electrical installation
Warning! Live Electrical Components!
During installation, testing, servicing and troubleshooting of this product, it may be necessary to work
with live electrical components. Have a qualified licensed electrician or other individual who has been
properly trained in handling live electrical components perform these tasks. Failure to follow all electrical
safety precautions when exposed to live electrical components could result in death or serious injury.
Meets cULus requirements without the need of an electrical ground connection.
Actuators with appliance cables are numbered.
Provide overload protection and disconnect as required.
Actuators may also be powered by 24 VDC.
Only connect common to negative (-) leg of control circuits.
A 500 Ω resistor (ZG-R01) converts the 4...20 mA control signal to 2...10 V.
Control signal may be pulsed from either the Hot (Source) or Common (Sink) 24 Vline.
For triac sink the Common connection from the actuator must be connected to the Hot connection of the
controller. Position feedback cannot be used with a triac sink controller; the actuator internal common
reference is not compatible.
IN4004 or IN4007 diode. (IN4007 supplied, Belimo part number 40155).
Actuators may be controlled in parallel. Current draw and input impedance must be observed.
Master-Slave wiring required for piggy-back applications. Feedback from Master to control input(s) of
Slave(s).
On/Off Floating Point
VDC/mA Control PWM Control
Override Control Master - Slave