User guide
Table Of Contents
- Belgacom Forum™ 525/526
- Mounting and Commissioning
- Contents
- About this Manual
- Features
- Factory Settings on Delivery
- Update Notes
- Installation
- Forum Phone 515 / 525 / 535: Extensions and Accessories
- Mounting the Forum 526 Rack InfoCom System
- Configuration
- Brief Guide to Initial Configuration
- Configuring the Forum 525/ 526
- Preparing the Configuration
- Starting the Web Console
- Loading the Online Help
- Finishing the Configuration
- Saving and Loading the Configuration
- Preconfiguration
- Remote Configuration
- Codes for IP Configuration
- Receiving System Messages as E-Mail
- Loading SW Updates
- Resetting the System Data
- Basic Hardware Settings Switch
- Generating Your Own MoH Files
- Configuration Examples
- Voice over IP (VoIP)
- DECT over IP®
- PBX Cascading
- PBX Networking
- Telephony
- Team Functions
- Call Queue
- Multi-Company Variant
- Configuring the PC Software
- Application Interfaces
- Frequently Asked Questions
- Technical Specifications
- Environmental Information
- Index
- Contents
- Technical support for your Forum® telephone exchange
VoIP System Telephones124
Voice over IP (VoIP)
The “IP Phone Configurator” dialogue opens. Select the desired
language setting (“English” or “German”)from the drop-down
menu.
2. Enter the network address of the VoIP system telephone. You
have two connection types to choose from under Connection
to IP Phone:
– Deactivate the IP Phone address option to establish a
broadcast connection via “UDP-Broadcast”. You have to select
this type of connection if the VoIP system telephone has not
yet been assigned an IP address. IP broadcasts cannot be
transmitted via router. The VoIP system telephone thus has to
be directly connected to your PC via a hub or via a switch.
– Activate the IP Phone address option to establish a point-
to-point connection via “UDP-Unicast”. Enter the IP address of
the VoIP system telephone into the entry field. You can select
this type of connection if the VoIP system telephone has
already been assigned an IP address.
3. Enter the MAC address of the VoIP system telephone. You will
find the MAC address on the underside of the device. Click on
List configuration. The status bar at the bottom edge of the
programme window displays “list OK”.
4. Change the desired settings under Configuration of the IP
Phone. Click on Reset configuration to activate the
standard settings for all entry fields.
5. Click on the Send configuration command to transfer the
currently shown configuration to the VoIP system telephone.
The status bar at the bottom edge of the programme window
displays “send OK”.
Note: The VoIP system telephone receives the configuration and
sends a response. The new configuration is only saved and acti-
vated once this has happened. This can result in the “IP Phone
Configurator” not receiving the response of the VoIP system tele-
phone.
Please note: If you are operating multiple network cards with
active IP configuration in your PC, this may mean that the loading
of configuration data fails. First you deactivate additional network
cards or use a point-to-point connection. Sending configuration










