User guide

Configuring the Forum 523/524 83
Configuration
Setting up an Internet Connection from
Remote (ISP Trigger Call)
Z (reserved tel. no.) Z (system PIN) * #
If the communications system is connected to the Internet via a
dialup connection, a user can initiate from external that the sys-
tem establishes an Internet connection (ISP Trigger call). The sys-
tem is then reachable via the Internet and enables to set up a
connection for a VPN connection via RAS.
Loading SW Updates
New versions of the system and terminal software can be loaded
to the system.
New software versions of the Forum 523/524 are loaded from the
configuration PC, which accesses the Configurator (see the Sys-
tem: Firmware menu). For information on connecting a configu-
ration PC, see Brief Guide to Initial Configuration on page 73.
The terminal software is part of the Forum 523/524 software and
is automatically loaded into the terminals via the Forum 523/524
if the software version in the terminal is different from the termi-
nal software stored in the Forum 523/524.
For further information, refer to the online help documentation
under the item System: Firmware.
Resetting the System Data
You can restore the factory settings of the Forum 523/524 in the
Configurator. If this is not possible, refer to the next section enti-
tled Basic Hardware Settings Switch.
Please note: If this is done, all individual settings and the user
data are then lost. For this reason, you should back up your con-
figuration regularly, the best time to do so being after every
change. For details, refer to the chapter entitled Saving and Load-
ing the Configuration starting on page 78 and to the Web console
online help.