User guide

Mounting 47
Installation
Mounting
The device must be mounted in a suitable place. Please see the
section on Mounting Location starting on page 35 for details. The
Forum 523/524 is attached to the wall by means of 3 screws as
shown in the diagram below:
Attachment diagram
Take the cover off the Forum 523/524 to screw in the screws for
attchment point B and insert the screws through the holes pro-
vided. The Forum 523/524 will hang on the screws in attachment
point A, so you must leave a space of 4 mm between the screw
heads and the wall.
6. Tighten the Velcro fastener.
7. Replace the cover and connect the
power cable to the power supply unit
(see Opening and Closing Forum 523/
524 starting on page 36).
A
B
B
266 mm
290 mm
Mounting hole Mounting hole
Suspension (backside of device)