Datasheet

39200 Series
Shielded Plug Assembly Instructions
Bel Stewart Connector Page 1 of 2 MN390016 Rev A0
1 to 1 ½”
SHIELDING
over jacket
 Cut cable to length. Insert cable into the boot
if used.
 Strip the jacket back 1 to 1 1/2 inches.
 Fold braid, or drain wire and foil back over the
jacket. Wrap the drain wire around the foil if
present.
01
ORANGE
PAIR
BROWN PAIR
NOTCH IN WIRE
ALIGNER
 Orient the Orange pair up and the Brown
pair down.
 Insert the wire aligner so the notch is facing
right. The Blue and Green pairs should
straddle the wire aligner in the shallow chan-
nels. (Either the Blue or Green pair may be
in front depending on which the end of the
cable is used.)
 Keep the aligner tight against the jacket.
 Untwist the wire pairs. Stop untwisting at the
edge of the wire aligner.
02
 Spread the wire pairs apart.
 Carefully cut away any spline or filler strips
from the end of the cable. Cut as close to the
edge of the jacket as you can without nicking
the wire insulation.
03
04
 Smooth out the wires as straight as pos-
sible.
 Align wires to standard (T568B Shown
above).
 Trim off a little of each wires so the ends
are all even. Leave at least 3/4 of an inch
sticking out of the wire aligner.
Pin # Wire Color
1
ORANGE/WHITE
2
ORANGE
3
GREEN/WHITE
4
BLUE
5
BLUE/WHITE
6
GREEN
7
BROWN/WHITE
8
BROWN
# 1
# 8