Datasheet

39200 Shielded Large Conductor
Plug Assembly Instructions
Bel Stewart Connector Page 2 of 2 MN390015 Rev A0
 Bend the solid color wires down slightly.
 Insert the ends of the wires into the load
bar keeping the slots toward you (see
picture).
 Pull the wires through the load bar and
seat the load tight against the wire
aligner.
 Trim off the wires flush to the end of the
load bar
05
BEND 4 SOLID COLOR WIRES
(2, 4, 6, & 8) DOWNWARD
SIDE OF LOAD BAR
WITH SLOTS
PUSH LOAD BAR OVER WIRES
07 08
 If using shielded cable, the shield fingers
should contact the foil, drain wire and/or
braid.
 Fully insert the plug into the termination
tool and close the handle.
 Remove the terminated plug from the tool
using the release button.
 Trim off any excess shield if used and
snap the boot in place.
 Inspect and test your cable.
BEND
BEND
06
 Insert the load bar and wires into the back of
the plug housing keeping the plug contacts
toward you.
 Push the loadbar in until it is fully seated
against the front of the plug housing.
 Ensure that the wires have not backed out of
the load bar.
 Bend shield fingers in toward the cable.