Datasheet

Bel Stewart Connector
Instruction Sheet MN390011
Page 8 of 8 Rev A1
If used, align the strain relief grommet and push it over the terminated
plug body. Snap it in place.
Repeat the above procedure for the other end of the patch cord.
Test the completed cable assembly to ensure that it meets your
performance requirements.
PUSH
PUSH
15
Insert the un-terminated plug into the crimp
tool. Make sure that the plug is fully seated
in the tool. Squeeze the handles of the crimp
tool together until they are fully depressed,
and will open when the handle is released.
13
Remove the terminated plug from the crimp
tool and trim off any excess foil and drain
wire.
14