Datasheet

Bel Stewart Connector
Instruction Sheet MN390011
Page 7 of 8 Rev A1
Bring the loadbar down, tight against the plastic
wire aligner. Trim the wires flush to the loadbar.
10
Wrap the drain wire around the foil near the wire aligner.
Keep the orange pair to the left. Push the assembled wires,
loadbar, and plastic wire aligner into the plug body
subassembly. The plug latch tab should be facing away
from you. Firmly push the plug until the wires come in
contact with the front inside surface of the plug.
11
Arrange the wire colors so that they match the T568B color map. Keep the orange pair on left and the brown pair
on right. Do not add or remove more than
½ of a twist to any pair to achieve this color pattern.
ORANGE ORANGE GREEN BLUE BLUE GREEN BROWN BROWN
/WHITE /WHITE /WHITE /WHITE
Color pattern above represents an example of the wiring colors used by one manufacturer. Wiring colors may vary by cable.
Please verify the color pattern specific to your particular requirements.
8
SLOTS WEDGE
Trim the ends of the wires to make them even. This will
make it easier to insert the wires into the load bar.
Remove the least amount of wire necessary. Insert the
ends of the wires into the wide end of the load bar,
maintaining the wire color sequence. The side with the
slots and the wedge shaped end should be facing towards
you.
9
Bend the plug shield fingers inward toward the
cable. Press the shield fingers as far as they will
go. They should easily fit into the Shield Crimp
portion of the crimping tool.
SHIELD
FINGERS
12