Datasheet

Bel Stewart Connector
Instruction Sheet MN390011
Page 6 of 8 Rev A1
BROWN PAIR ORANGE PAIR
5
Separate the 4 wire pairs.
Place plastic wire aligner between the pairs. The tapered end should be toward the braid and jacket. The orange pair will
go to the deep channel on the left side and the brown pair will go toward the deep channel on the right. The blue and green
pairs will go to the sides that have shallow channels at the middle. On one end of the cable the blue pair will be towards
you, and the green pair will be towards you on the other end.
6
END WITH
BLUE PAIR IN
FRONT
END WITH
GREEN PAIR
IN FRONT
Make sure that the wire aligner is tight to the cable jacket. Untwist the wire back to the top of the wire aligner. Straighten the
exposed wires as flat as possible.
7
END WITH
GREEN PAIR
IN FRONT
END WITH
BLUEPAIR IN
FRONT
Trim away any plastic film, spacers, or wire
spline. All should be flush with the cable jacket.
4
WIRE SPLINE