Datasheet

Bel Stewart Connector

Instruction Sheet MN390011

Page 4 of 8 Rev A1

SHIELD

FINGERS

Bend the plug shield fingers inward toward the

cable. Press the shield fingers as far as they will go.

They should easily fit into the Shield Crimp portion

of the crimping tool.

Insert the un-terminated plug into the crimp

tool. Make sure that the plug is fully seated

in the tool.

Squeeze the handles of the crimp tool together until

they are fully depressed, and will open when the

handle is released.

Remove the terminated plug from the crimp tool.

If used, align the strain relief grommet and

push it over the terminated plug body. Snap

it in place.

Repeat the above procedure for the other end

of the patch cord.

Test the completed cable assembly to ensure

that it meets your performance requirements.

PUSH