Datasheet

Bel Stewart Connector
Instruction Sheet MN390011
Page 3 of 8 Rev A1
13
Keep the orange pair to the left and the brown to the
right. Push the assembled wires, loadbar, and plastic
wire aligner into the plug body subassembly. The
plug latch tab should be facing away from you.
Firmly push the plug until the wires come in contact
with the front inside surface of the plug.
Bring the loadbar down, tight against the plastic
wire aligner. Trim the wires flush to the loadbar.
10
Dress the braid to one side of the jacket.
11
12
Wrap the braid over the jacket. Press the foil
covered pairs fully into the slots in the channels of
the plastic wire aligner. Ensure that the foil does
not stick out as this makes it difficult to insert this
assembly into the plug body.