Datasheet

Bel Stewart Connector
Instruction Sheet MN390011
Page 2 of 8 Rev A1
.
Trim the ends of the wires to make them even. This
will make it easier to insert the wires into the load
bar. Remove the least amount of wire necessary to
even out the wires.
8
SLOTS WEDGE
Insert the ends of the wires into the wide end of
the load bar, maintaining the wire color sequence.
The side with the slots and the wedge shaped end
should be facing towards you
9
Push the wire aligner down as far as it will go and push pairs into wire aligner channels. Flatten out the wires and arrange the
insulation colors so that they match the T568B color map. Keep the red on left and the brown on right. On one end of the
cable the blue pair will be towards you, and the green pair will be towards you on the other end.
6
END WITH BLUE
PAIR IN FRONT
END WITH GREEN
PAIR IN FRONT
RED ORANGE BLACK BLUE WHITE GREEN YELLOW BROWN
The color pattern shown in these pictures represent the wiring colors used by one manufacturer. Wiring colors may vary by
cable. Please verify the color pattern specific to your particular requirements. Shown below is a more typical color scheme.
ORANGE ORANGE GREEN BLUE BLUE GREEN BROWN BROWN
/WHITE /WHITE /WHITE /WHITE
When aligning the wires to the color pattern, maintain the existing twist of the wire pairs. Do not add or remove more than
½ twist to any pair to achieve the required color pattern.
7