Specifications

The PRE3VB Remote Control has a comprehensive
set of control features that are not available on the
front panel.
To access all PRE3VB control features press the
button marked PRE on the remote control. The Main
CD controls will still operate in the DAC, PRE and
Tuner modes.
PGM: Used for programmable functions.
Display: Toggles through display modes. When in
OFF mode, the Display will come on momentarily
when operating the front panel or remote control.
Mute: When in variable output mode this will toggle
the analog outputs from Soft to Hard Mute and Un-
muted modes. Soft mute is indicated by two decimal
points in the far right of the display . . and Hard mute
is indicated by 4 decimals on the display . . . .
VOL>: Increases the volume setting in Variable
Output mode. This will Punch Through to any Bel
Canto unit in Variable Output mode. The display will
show the volume level while changing.
<VOL: Decreases the volume setting in Variable
Output mode. This will Punch Through to any Bel
Canto unit in Variable Output mode. The display will
show the volume level while changing.
CH/SCAN+: This will toggle the input selection up in
number and wrap around. Note that the first press of
this control will show the active input selection.
CH/SCAN-: This will toggle the input selection down
in number and wrap around. Note that the first press
of this control will show the active input selection.
Number Buttons: These will directly select the
inputs numbered from 1-5 and Balanced IN (6).