Specifications

• On the lower left corner of the VBS1 back panel is the AC inlet jack. Connect this jack to an AC power
outlet in your home using the included AC power cord. Make sure the AC power outlets in your home
have properly functioning grounding. DO NOT use any ground lift adapter plug or ground defeating
apparatus at any time. DO NOT remove the grounding prong of the power cable at any time. Improper
grounding of the VBS1 could cause the unit to malfunction, and can result in serious bodily injury or even
death.
• The center right side of the VBS1 back panel has three 12 volt DC output receptacles. Use the Bel Canto
supplied power interconnects to mate the VBS1 output receptacles to your VB equipped components.
(Make sure all units are powered OFF while making connections.)
• Be sure that the power switch is in the off (O) position before making any connections. On the upper left
corner of the VBS1 back panel is the AC power switch. To power the unit ON, flip the switch toward the
outside of the unit so that the side of the switch with the flat line is depressed
• Note that it will take the supply 3-5 seconds to fully charge up the internal storage capacitors when
turning the VBS1 on. When shutting the VBS1 off wait for 1-2 minutes before removing the power cables
to the e.One products to ensure that the VBS1 is fully discharged. Check that the blue LED indicator lamp
is not lit before removing the VBS1 cables.
Low Noise DC power source for use with up to 3 e.One VBS1 compatible source or control components
Maximum power dissipation: 50 watts
Typical power dissipation: <20 watts driving 3 devices
Internally Set Operating Voltages: 100-120 VAC 50/60 Hz or 200-240VAC 50/60 Hz
Dimensions: 8.5” W x 12.5” D x 3” H (216 mm x 318 mm x 75 mm)
Weight: 15 Pounds, 7 Kilograms