Specifications

The CD2 Remote Control has a comprehensive
set of control features that are not available on the front
panel control.
To access all CD2 control features press the button
marked CD on the remote control.
e.One DAC or Preamp functions can be controlled by
selecting DAC or PRE on the remote. The Main CD
controls will still operate in the DAC and PRE modes.
Display: Toggles the Display ON and OFF. When in OFF
mode, the Display will come on momentarily when
changing the CD2 operation.
Mute: In variable output mode this will switch the analog
outputs from Soft to Hard Mute and Un-muted modes. Soft
mute is indicated by two decimal
points in the far right of the display. Hard mute is
indicated by 4. If you are not using your CD2 and
would like to keep it powered ON, Hard muting is
recommended.
Pause ||: Toggles the Pause mode ON and OFF. The
Mode Indicator will show the pause or play mode as
appropriate.
Stop: Indicated by a solid square and will place the CD2
in Stop mode when pressed. The CD2 will remain on the
current track and re-start the track when Play is pressed.
PLAY>: Initiates playback of the displayed track.
VOL+ : Increases the volume setting in Variable Output
mode. This will Punch Through to any Bel Canto unit in
Variable Output mode. The display will show the volume
level while changing.
VOL- : Decreases the volume setting in Variable Output
mode. This will Punch Through to any Bel Canto unit in
Variable Output mode. The display will show the volume
level while changing. See Page 7 for an explanation of
Fixed/Variable output modes.
|<<: Track Decrement to reduce the track number.
>>|: Track Increment to increase the track number.
<<: Slow playback speed in real time. Pressing twice will
reduce speed further, press Play to resume normal
playback.
>>: Increase playback speed in real time. Pressing twice
will increase speed further, press Play to resume normal
playback.
Rpt1: Repeat playback of the current track while in play
mode. The Mode Indicator changes from the bottom left
corner to the top left corner to indicate mode. Press Rpt1
to turn the repeat mode off. Stopping playback will also
turn the repeat mode off.
Rpt All: Repeat playback of the entire CD while in play
mode. The Mode Indicator changes from the bottom left
corner to a full height Mode Indicator to indicate this mode.
Press Rpt All to turn the repeat mode off. Stopping
playback will also turn the repeat mode off.
TIME: Shows the track time played while the CD is playing
or Paused. Pressing the TIME button will change the
Display back to standard mode.
Number Buttons: The 1-9 and 0 buttons are used to
directly select any track number for playback. Track 10
and above are directly selected by keying in the number. If
you select a track beyond the number of tracks on the CD
no action will result and the current track will continue
playing.
No other remote buttons are active for use with the CD2.