Instructions / Assembly

STEP 1
Unscrew the screw, then take out the hanging plate
Assembly Instructions
WALL LANTERN
page 2
STEP 2
Use the mounting screws to attach the mounting unit to the junction box
STEP 3
Make the electrical connection from the junction box to the
fixture. Connect the ground wire to the mounting unit using the
preinstalled green ground screw. Then, connect the positive,
negative and ground wires with the supplied wire nuts. Secure
with electrical tape
Connect Clear, Brown, Gold or
Black Parallel Wire without tracer
(round & smooth) or Black Fixture
Wire to:
Black or Red Supply Wire or
Insulated Wire (other than green)
with copper conductor.
Connect Clear, Brown, Gold or
Black *Parallel Wire with tracer
(square & ridged) or White Fixture
Wire to:
White Supply Wire or Insulated
Wire (other than green) with silver
conductor
Copper
Smooth
Silver
Ridged
STEP 4
Fix the lamp body on the hanging plate and tighten the screws
STEP 5
Take out the top cover
STEP 7
Fasten the top cover
STEP 6
Install bulb(Not Included)
PAR30 TYPE
The rubber ring must be
stuck in the middle
position
!