User Guide

SAFETY FIRST!
ELECTRICAL REQUIREMENTS (WHEN CONNECTED TO MAINS SUPPLY)
Before you insert the plug into the wall socket make sure that the voltage and the frequency
shown in the rating label loccated inside of the right hand side panel at the back of the
appliance corresponds to your electricity supply. Rating label is on the apper left side
of the back wall. We recommend that this appliance is connected to the mains supply
via a suitably switched and fused socket in a readily accessible position.
Should the mains lead of the appliance becom damaged or should it need replacing at
any time, it must bee replaced by a special purpose made mains lead which can only
be obtained from an Authorized Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then plug should cut off and an
appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord
could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to
be replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not
forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be
used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover
must be the same colour as that visible on the pin face of the plug. Fuse covers available
from any good electrical store.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying
the terminals in your plug proceed as
follows: (See diagram).
1. Connect the green-Yellow or green
(Earth) wire to the therminal in the plug
marked ‘E’ or with the symbol
or coloured green and yellow or
green.
2. Connect the blue (Neutral) wire to
the terminal in the plug marked ‘N’ zor
coloured black.
3. Connect the brown (Live) wire to the
terminal in the plug marked ‘L’ or coloured
red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the
main fuse box.
If in doubt contact a qualified electrician.
3
FUSE
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLECAMENT
CARTTRIDGE FUSE
CORD GRIP
BLUE
OR
BLACK
GREEN &
YELLOW
OR
GREEN
N
L
6 mm
BROWN
OR
RED
32 mm
22 mm
12 mm
6 mm
6 mm