R E F R I G E R A T I O N Printed in Turkey Part no: MR52 IB 039901 Beko (UK) Ltd. Beko House Caxton Way Watford Hertfordshire WD 18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko.co.uk website: www.beko.co.uk • MR 52 (Mains Operated) • MR 62 (Mains or Battery Operated, 12V) 1.5 cu.
Congratulations on your choice of a Quality Mini - Bar which has been designed to give you service for many years. WARNING! IMPORTANT! DO NOT-connect the Mini - Bar to the electricity supply until all packing and transit protectrs have been removed. • Leave to stand For at least 4 hours before switching on to allow system to settle if transported horizontally.
CONTENTS PAGE SAFETY FIRST / ELECTRICAL REQUIREMENTS (MAINS OPERATION) 3 BATTERY OPERATION (MR62 ONLY) 4 TRANSPORTATION INSTRUCTIONS 5 INSTALLATION INSTRUCTIONS 6 GETTING TO KNOW YOUR MINI-BAR 7 REPOSITIONING THE DOOR 8 TEMPERATURE CONTROL AND ADJUSTMENT 9 STARTING 9 MAKING ICE CUBES 9 DEFROSTING 10 CLEANING AND CARE 10 DO'S AND DON'TS 11 PROBLEM SOLVING 11 GUARANTEE DETAILS 12 2
SAFETY FIRST! ELECTRICAL REQUIREMENTS (WHEN CONNECTED TO MAINS SUPPLY) Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating label loccated inside of the right hand side panel at the back of the appliance corresponds to your electricity supply. Rating label is on the apper left side of the back wall. We recommend that this appliance is connected to the mains supply via a suitably switched and fused socket in a readily accessible position.
BATTERY OPERATION (MR 62 MODEL ONLY) Model MR is the dual voltage Mini - Bar, which operates from Mains supply or a 12V battery. WARNING! IMPORTANT! DO NOT CONNECT THE MAINS PLUG AND THE BA~TERY CONNECTION AT THE SAME TIME. ONLY ONE POWER SOURCE MUST BE USED AT ALL TIKES. Colours of the wires for battery operation are black (negative connection) and red (positive connection) When connected to a battery, the thermostat is by-passed therefore the Mini - Bar absorption system will operate non-stop.
TRANSPORTATION INSTRUCTIONS 1.The Mini - Bar should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the Mini - Bar has been transported horizontally, it must not be operated for at least 4 hours to allow the system to settle. 3. Failure to comply with the above instructions could result in damage occuring to the Mini - Bar.
IMPORTANT INSTALLATION INSTRUCTIONS 4. Avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the Mini - Bar to run for long periods. 2. Make sure that sufficient room is provided around the appliance to ensure free air circulation. Leave minimum 2 1/2" (60 mm) clearance on sides and 4 inch (100mm) clearance on the rear sides. 3. Do not cover ventilation slots as this will block the dissipation of heat generated at the back. 4.
• Place mini ice cube trays on the evaporator to make ice cubes. • Place large bottles in the Mini - Bar and not on door shelves. • Don't place fiuy drinks or any bottled / canned drink container on the evaporator. • Ensure ventilation slots are clear from any obstruction. • Parts at the back, including condenser will get hot during operation. Take care not to touch these surfaces.
REPOSITIONING THE DOOR Follow the step instructions and the diagrams below. Numbers in brackets refer to diagrams. 1. Switch off the Mini - Bar. 2. Remove beverages, loose items from door shelves. 3. Prise off plastic screw caps and unscrew two screws securing top hinge (1) using the special tool provided while holding the door. (You should keep the right hand side door opening top hinge in a safe place in case needed in Future.) 4.
TEMPERATURE CONTROL AND ADJUSTMENT Operating temperature is controlled by the thermostat at the bottom of the inner liner of Mini - Bar. (See diagram) Setting may be made from 1 to 5, the coldest position. Turn the thermostat knob clock - wise to obtain a colder temperature and vice versa. When the appliance is switched on for the first time, the thermostat should be adiusted so that after 24 hours, the average temperature is no higher than +5 degrees C (+41 degrees Fl.
DEFROSTING Frost will gradually from on evaporator surface of the Mini - Bar will decrease when thick frost accumulates on the evaporator. Defrost when the frost layer on the evaporator reaches about approx. 1/4" (6 mm). To start the defrosting procedure switch off at the socket outlet and open the door. Defrost water will drip into the drain tray underneath the evaporator and via a tube will be collected in an evaporating container at the back.
DO’S AND DON’TS DoClean and defrost your Mini - Bar regularly DoEnsure sufficient ventilation is provided around the Mini - Bar Don’t- Leave the door open for long periods as this will make the Mini - Bar more costly to run. Don’t- Cover the shelves with any material Don’t- Store poisonous or any dangerous substances in the Mini - Bar. Don’t- Use pointed or sharp edged obiects such as knives, forks to remove the frost.
GUARANTEE DETAILS This product is guaranteed for twelve months from the date of original purchase. Any defect that arises due to faulty materials or workmanship will sbe repaired free of chorge during this period. The guarantee is subject to the following provisions: The guarantee does not cover accidental or transportation damage, misuse, cabinet parts, knobs, or consumable items e.g. bulbs and food loss, and consequential cots correcting improperly installed product. Beko (UK) Ltd.
