Technical data

39
Compressed Air Applications Manual | BEKOFLOW
®
HWSG-3 resistance
welding tool
Compressed Air Applications Manual | BEKOFLOW
®
HWSG-3 resistance
welding tool
Start the welding process by pressing
the Start button. The Welding light
will blink; the welding start will also be
indicated by an acoustic signal.
The Ready light of the connected
welding channel will blink.
4.After termination of the longest weld-
ing time, the end of welding will be
indicated by an acoustic signal and by
lighting up of the End pilot light.
The Ready light of welding channels
with shorter welding times will go out
when the time is over.
5.Disconnect the welding cables from
the fitting. Only the Power light will still
be on; all three welding channels are
now free again
6. Checking the welding results
The visual welding indicator confirms
the termination of the welding process.
The indicator consists of a pin that ap-
pears on the coupling when the weld-
ing has been successfully completed.
During the welding process, the fittings
and pipes being welded must only be
subjected to the forces stemming from
the original fixing of the pipe.
Technical Data
Voltage: UPrim 230 V
USek 185 V
Frequency: 50/60 Hz
Current: IPrim 7.5 A
ISek 3x2.5 A
Output: PPrim 25-1 400 W
Device No.
Maintenance
Clean the welding device with a damp
cloth. Only use alcohol or spirits for
cleaning front panel and plates; do not
use thinners or solvents.