Technical data

23
Compressed Air Applications Manual | Pipework design and installation Compressed Air Applications Manual | Pipework design and installation
Normal mounting on ceilings, walls or
other carriers using pipe clamps
Mounting on/along pipework routes using
pipe clamps
Mounting system using pipe clips
Mounting on a cable duct using pipe clips
Installation in a cable duct
Inside the cable duct, the pipe can be
fixed with cable binders.
Rigid or flexible pipe installation
Depending on the type of installation – ri-
gid or flexible – the correct arrangement
of fixing points is very important.
For feeder branches, fixing points (FP)
should be arranged according to the lo-
cal conditions.
In the case of ring lines, the fixing points
(FP) should be located at the ring inlet,
in the area of shutoff valves and, where
appropriate, at the junctions of the cross
pipes.
FP at the ring inlet
FP at shutoff valve
FP at T-piece
Caution:
Any heavy valves
or other devices
incorporated into
the line must be
fixed separately.