FEATURES OF 2008 DVD PLAYER Full discs playback compatibility: DVD,DVD±R,DVD±RW, DVCD, MP3, CD-DA, HDCD , Picture CD. Excellent AV effect: 1.Composite video, S-Video and component video output. Built-in progressive output enables a higher resolution of the pictures. 2.Supports PAL or NTSC system with aspect ratio of 4:3 or 16:9. Fiber optical and coaxial audio outputs are also available. Totally supports multi view-angle, multi-language, multi-subtitle and multi screen mode for DVD discs.
OPEN/CLOSE POWER MUTE 1 2 3 4 5 6 AUDIO SUBTITLE 7 8 0 +10 9 RETURN SEARCH CLEAR ANGLE TITLE DISPLAY MENU PBC ENTER SETUP VIDEO PLAY STOP FB FF A-B REPEAT SLOW ZOOM PAUSE/STEP PREV - VOL PROGRAM NEXT + N/P SCART Cord
2008 Playback Playback DIVX VIDEO 20-22 23 24 25
Front Panel/Rear Panel Front Panel STOP OPEN/CLOSE POWER DISC TRAY VFD SCREEN PLAY/PAUSE Rear Panel COMPONENT Cb/Pb COMPONENT Y COMPONENT Cr/Pr COMPOSITE VIDEO OUT SUBWOOFER SCART OUTPUT 2008 SBN CENTER AUDIO (L) AUDIO (R) OPTICAL FIBER S-VIDEO COAXIAL OUTPUT 6
DVD VFD DVD VFD MP3 INDICATOR PBC INDICATOR ANGLE INDICATOR DOLBY INDICATOR CD, VCD, SVCD INDICATOR DTS INDICATOR DVD INDICATOR SVCD PBC ALL CHAPTER / TRACK NUMBER INDICATOR REPEAT PLAYBACK INDICATOR TIME INDICATOR PLAY/PAUSE INDICATOR Notes: It is normal if some VFD indicators disappear in playing procedure without harm.
Remote Control OPEN/CLOSE POWER MUTE 1 2 3 4 5 6 7 8 9 0 +10 RETURN SEARCH AUDIO SUBTITLE CLEAR ANGLE TITLE DISPLAY MENU PBC ENTER SETUP VIDEO PLAY STOP FB FF A-B REPEAT SLOW ZOOM PAUSE/STEP PREV - VOL PROGRAM NEXT + N/P 1.POWER: switch DVD player on or go to standby mode 2.PROGRAM: program playback 3.AUDIO:audio language selector 4.ANGLE: select DVD camera angle 5.SUBTITLE:subtitle language selector 6.PBC:open or close the PBC(VCD2.0) 7.ZOOM: enlarge video image 8.
Operating with the Remote Control Preparations for the Remote Control Insert the batteries into the remote control, and you can use it to operate DVD player. 1 This section shows you how to use the remote control. Point the remote control at the remote sensor and press the buttons.
Connecting to a TV Connect the DVD player to a TV. Connecting to an Interlaced Scanning TV COMPONENT VIDEO OUTPUT MODEL:SH318H COMPOSITE VIDEO OUTPUT AUDIO OUTPUT (R) AUDIO OUTPUT (L) TV S-VIDEO OUTPUT Notes: (1)If the TV has component video input (YcbCr/YPbPr) jacks, you can connect them to the YcbCr/YPbPr jacks of the DVD player to get a clearer picture, and use these jacks rather than the S-VIDEO OUTPUT jack. (2)DVD player setup: (Setup the DVD player according to the connected TV.
Connecting to a TV Connect the DVD player to a TV. Connecting to a Progressive Scanning TV COMPONENT VIDEO OUTPUT SCART OUTPUT AUDIO OUTPUT (R) AUDIO OUTPUT (L) Notes: 1.Select progressive when you have a TV that can accept progressive signals to enjoy accurate color reproduction and high quality images. 2.If your TV has a component video (YPbPr) input connector , connect the YPbPr video out jacks on the DVD player to corresponding input on the TV. 3.
Connecting to an Audio System You can enjoy the sound of discs in stereo. Connecting to the Amplifier System COMPOSITE VIDEO OUTPUT TV MODEL:SH318H AUDIO OUTPUT(R) AUDIO OUTPUT(L) Notes: Refer to the user’s manual of the connected equipment as well. When you connect the DVD player to other equipment, be sure to turn off the power and unplug all the equipment from the wall outlet before making any connections.
Connecting to an Audio System Connecting to the Amplifier with Digital Input Port Dolby Digital Dolby Digital is the surround sound technology used in theatres showing the latest movies, and is now available to reproduce this realistic effect at home. You can enjoy motion picture and live concert DVD video discs with this dynamic realistic sound by connecting the DVD player to a 5.
Connecting to the Amplifier with 5.
Basic Playback Preparations If you want to play a DVD, VCD or CD-DA disc, turn on the TV and select the video input source which is connected to the DVD player. If you want to enjoy the sound of disc from the audio system, turn on the audio system and select the input source which is connected to the DVD player. For connection details, see ‘Connections’. 1.Turn on the DVD player Press the POWER button on the front panel, And then press the PLAY button to wakeup the DVD.
Enjoy pictures of higher quality Sometimes when playing DVD discs, on the TV screen there is unusual interference that are not common in ordinary television broadcast. This is because the high-resolution pictures of DVD discs contain a wide range of information. The extent of the interference depends on the TV set connected with the DVD player, and it is recommended that you set the TV set to a low contrast ratio when watch a DVD disc. Playback Control 1.
Playback Control 14.SEARCH Press this button to search the playback point by chapter number or title time (for DVD discs), disc time or track time or track number (for SVCD/VCD/CD discs) 15.N/P Press this button to swith the TV type ,NTSC-PAL-AUTO Set Hot Button 16. DISPLAY Press this key to display on TV the time information of current playback. For different discs, different choices are available. 17. MENU For DVD discs, press this button to enter DVD menu (if supported by the discs). 19.
Screen Saver Function Volume Control 26. VOLUME With an analog Audio connection . The volume can be adjusted using the VOL+ and VOL- buttons . The volume can be muted by pressing the MUTE button on the remote control. 27. MUTE Press this button to set the play mute, press this button again to cancel the mute state. In the stop status and when no discs in the player, the player will enter screen saving status automatically 3 minutes later. Press the PLAY button or OPEN/CLOSE button to resume the player.
Playback Divx© VIDEO 3 Open the folder with È >>OK<< or >> <<. 2 Move the freeze frame step by step forwards with >> << . to resume normal playback. 3 Press >> << È Note: Press >> RETURN << È to go back one level. 4 to start playback of the track. Press >> << È - The playing time appears in the display on the DVD player. Notes: Information about the DivX Video track selected can be called up with >>ENTER<<. The contents of the DivX© Video CD (file browser) È be called up with >> RETURN <<.
Function Setup Press the SETUP button, the following graphic will display on the screen. SYSTEM SETUP TV SYSTEM SCREEN SAVER VIDEO TV TYPE PASSWORD RATING DEFAULT EXIT SETUP SYSTEM SETUP SYSTEM SETUP NTSC PAL SCREEN SAVER >> VIDEO >> TV TYPE >> PASSWORD >> RATING >> DEFAULT >> EXIT SETUP Video setup has four options . If using INTERLACEYUV output to TV , choose INTERLACE-YUV mode. If using P-SCAN YPBPR output to TV , choose P-SCANYPBPR mode TV TYPE 1.Press the SETUP menu to enter the setup menu. 2.
Function Setup LANGUAGE SETUP OSD LANGUAGE >> AUDIO LANG >> SUBTITLE LANG >> MENU LANG >> AUDIO SETUP LANGUAGE SETUP ENGLISH GERMAN SPANISH FRENCH TURKISH CHINESE ENGLISH TURKISH FRENCH SPANISH PORTUGUESE LATIN GERMAN CHINESE ENGLISH TURKISH FRENCH SPANISH PORTUGUESE GERMAN OFF CHINESE ENGLISH TURKISH FRENCH SPANISH PORTUGUESE GERMAN LATIN AUDIO OUT >> AUDIO SETUP SPDIF/OFF SPDIF/RAW SPDIF/PCM EXIT SETUP AUDIO OUT Audio output includes three different types : for common AV output , pleased choose
Function Setup VIDEO SETUP DOWNMIX VIDEO SETUP - - - - - - - - - - - - - - - BRIGHTNESS>> CONTRAST>> HUE>> - SATURATION>> - LT/RT is recommended if the discs support PROLOGIC DOLBY STEREO , you can enjoy clear and superior sound effect as in the cinema. If the discs support 5.1 channal output , STEREO is recommended .
On Handing Discs On Discs Do not touch the playback side of the disc. Disc mark Contents Maximum playback time Disc size Approx.2 hours(single sided single layer disc) Playback side DVD video discs Audio+video (motion picture) 12cm Approx.4 hours(single sided double layer disc) Approx .4 hours(double sided single layer disc) Do not attach paper or tape to discs. Approx.
Notes on Service Check the following guide for the possible cause of a problem before contacting service. Symptom Cause No power The power plug is disconnected Measure Connect the power plug into the wall outlet securely The TV is not set to receive DVD signal output No picture No sound The video cable is not connected securely Connect the audio cable into the jacks securely.
Specifications DVD Player/Outputs/Supplied Accessories DVD Player Power Supply ~110V-~240V AC,50/60HZ Power Consumption ≤15W (Normal Playback State) Mass Size Signal system Laser 2.5Kg+0.25 430x255x38mm(W/H/D) PAL/NTSC Semiconductor Laser ( wavelength 650nm,780nm) Frequency Response 土3db(20HZ-20KHZ) Signal-to-noise ratio ≥90db Audio dynamic range ≥80db Temperature:-5.C ~40.C, Operation status: Horizontal Operating conditions Outputs Composite Video Output 1.0±0.
