Dryer User manual 2960310534_KM/280814.
Read this manual prior to initial operation of the product! Dear Customer, We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results. We advise you to read through this manual carefully before using your product and keep it for future reference. This User Manual will • Help you use your machine in a fast and safe way. • Read the User Manual before installing and starting your product.
1 Important safety information This section includes safety information that will help protection from risks of personal injuries or materialistic damages. Failure to follow these instructions shall cause any warranty and reliability commitment to become void. General safety • • • • • • • • • • • • • • • • Never place the machine on a carpetcovered floor, otherwise, lack of airflow beneath the machine may cause electrical parts to overheat. This will cause problems with your machine.
• • • • • • • • • • • • • • • • know or have the ability to perform unless it is clearly suggested in the operating instructions or the published service manual. Inside and exhaust duct of the product must be cleaned by the qualified service personnel periodically. Wrong connection of grounding conductor of the product can cause electric shock. If you have any suspect about the grounding connection, have it checked by a qualified electrician, service representative or service personnel.
2 Installation It is the customers responsibility to arrange a suitably qualified installer to correctly install this product. CPreparation of location and electrical installation for the product is under customer’s responsibility. BInstallation and electrical connections must be carried out by a qualified personnel. APrior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products will cause risks for your safety.
BThe ventilation hose should not be connected to the chimney of a stove or a fireplace. BDo not operate your product at the same time with heaters such as a coal or gas stove. Airflow may cause the chimney to flare up. • The main fuse and switches must have a contact distance of minimum 3 mm. BDamaged power cable must only be replaced by a qualified electrician.
Technical Specifications EN 2 Height (adjustable) 84,6 cm Width 59,5 cm Depth 53 cm Capacity (max.) 7 kg Weight (net) 32 kg Voltage Rated power input See type label Model code Type label is located behind the loading door.
3 Initial preparations for drying Things to be done for energy saving: • Make sure that you operate the product • • • • • • • • • • • at its full capacity but pay attention to not exceeding it. Spin your laundry at the highest speed possible when washing them. Thus, the drying time is shortened and energy consumption is decreased. Pay attention to dry same types of laundry together. Follow the instructions in the user manual for programme selection.
• • • Garments or pillows bolstered with rubber foam (latex foam), shower bonnets, water resistant textiles, materials with rubber reinforcement and rubber foam pads should not be dried in the dryer. Do not use fabric softeners and anti-static products unless they are recommended by the manufacturers of the fabric softener or the product. Do not dry the underwear reinforced with metal parts in the dryer. If these metal reinforcements loosen and break during drying, they will damage your dryer.
4 Selecting a Programme and Operating Your Machine Control panel 1 2 3 4 Mini Time Delay 3h 6h 9h Clean Filter Drying Ready to Iron Ready to Wear End / Anticrease Start/ Pause Shirts Ready to Iron Freshen Up Ready to Wear 20 min. Ready to Wear Ready to Wear Plus 10 min. Extra dry 40 min. Reset 3’’ Timer Programmes 7 6 Synthetics Ready to Iron 60 min. Buzzer Cancel Jeans Delicates On / Off Cottons 5 1. Filter cleaning warning light 5. Programme selection knob 2.
Preparing the machine 1. Plug in your machine. 2. Place the laundry in the machine. 3. Press the “On/Off” button. C Pressing the “On/Off” button does not necessarily mean that the programme has started. Press "Start/Pause/Cancel" button of the machine to start the programme. Programme selection Decide the appropriate programme from the table below which includes drying temperatures in degrees. Select the desired programme with the programme selection button.
Program selection and consumption table 2 EN Programs Capacity (kg) Spin speed in washing machine (rpm) Approximate amount of remaining humidity Drying time (minutes) 1200-1000 % 60 135 900-800 % 70 150 1200-1000 % 60 75 Cottons / Coloreds 7 A Ready to Wear 3.5 7 A Ready to Wear Plus 3.5 7 A Ready to Iron 3.
Auxiliary function Cancel audio warning Your dryer will give an audio warning when the programme comes to an end. If you do not want to hear the audio warning, press “Cancel Audio Warning” button. The relevant light will turn on when this button is pressed and an audio warning will not be given when the programme comes to an end. CYou can select this function either before or after the programme starts. Warning indicators CWarning indicators may differ according to the model of your dryer.
Child-proof lock of the machine should not be active in order to perform these two operations. If the child-proof lock is active, deactivate it before performing these operations. Adding/removing laundry in standby mode In order to add or remove laundry after the programme starts: 1. Press the “Start/Pause/Cancel” button to switch the dryer to “Pause” mode. Drying process will stop. 2. Open the door at “Pause” position and close it again after adding or taking out laundry. 3.
5 Maintenance and cleaning Filter Cartridge / Door Inner Surface Lint and fibres released from the laundry to the air during the drying cycle are collected in the “Filter Cartridge”. C Such fibre and lint are generally formed during wearing and washing. C Always clean the filter and the inner surfaces of the cover after each drying process. C You can clean the filter and filter area by vacuum cleaner. To clean the filter: 1. Open the loading door. 2.
6 Solution suggestions for problems Drying process takes too much time • The filter mesh may be clogged. Wash with water. Laundry come out wet at the end of drying. • • The filter mesh may be clogged. Wash with water. Excessive laundry might have been loaded in. Do not overload the machine. Machine does not switch on or the program does not start. Machine is not activated when set. • It might have not been plugged in. Make sure that the machine is plugged in. • The loading door may be ajar.
