������������������������ ������������ Dishwasher DSFN 6830 � �� �� � � ��� � � � � ���� ��� ����������
Welcome Dear customer Congratulations on your choice of a Beko quality dishwasher which has been designed to give you lasting service. Please read these instructions before installing the dishwasher and using it for the first time. The information contained herein is provided to avoid accidental risks and/or damage to your appliance Make sure you understand the controls prior to using your appliance. The dishwasher must only be used for it’s intended purpose, i.e. the washing of dishes in the home.
TABLE OF CONTENTS 1 Know your dishwasher / specification 3 2 Warning and safety information 5 Electrical Safety Children’s Safety General Recycling Energy and water saving What should not be washed in your dishwasher 5 5 5 6 6 Electrical requirements 7 Warning This appliance must be earthed Important Fitting a different plug Water inlet hose connection Drain Hose Connection 8 8 8 8 9 9 6 3 Before first use 7 4 Installation 7 5 How to use 11 Water hardness & regeneration settings Water H
1 Know your dishwasher / specification ��������� �������� ��������� �������������� ������������� ����� ��������� ������������ ������������������������ ��������������� ���������������� ��������� ����� ��������� ������������������� ������������ �������������� ������� ������������������� ������������� ��������� ���������� ��������� ������������������ ����� 3 GB
Specification Load Capacity Height Width Depth Depth/Height (without worktop) Net weight Supply voltage Fuse currrent Total power Heater power Pump powers Diameter of plates for : Upper basket Lower basket : 13 Place settings : 850 mm : 598 mm : 598 mm : 570 mm / 820 mm : 47 kg : 220-240 V ~ 50 Hz : 13 A : 1900-2200 W : 1800 W : 105/30 W : 25 cm max. : 31 cm max. Because we continually strive to improve our products, we may change our specifications and designs without prior notice.
2 Warning and safety information Electrical Safety Never allow your children to play on or sit onto the front door when the front door is open. The dishwasher should only be operated on the voltage specified. For electrical safety, only earthed plugs and sockets should be used. Always use the fused plug provided with the appliance. The user is responsible for meeting these basic safety requirements.
The door of your machine is designed to support the weight of a full basket when the lower basket is pulled all the way out. Never place any other load on the door, otherwise the machine may tip over. human health due to the presence of hazardous substances. Energy and water saving Scrape excess food from the dishes before loading. Start your dishwasher after fully loading the machine. Do not use the pre-wash programme unless required.
If in doubt, contact the manufacturer of the item. Do not overload your dishwasher or do not load items other than those mentioned in this manual. 3 Before first use After unpacking your dishwasher, check the machine against any possible transportation damage. Never install and use damaged machines. If your machine is damaged contact your retailer. Always have your machine installed by qualified electrician/ plumber to ensure correct installation.
Warning This appliance must be earthed If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug, which is cut off as a plug with a bared cord could cause a shock hazard if inserted into a socket elsewhere in the house. The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be replaced an ASTA approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover.
Water inlet hose connection Drain Hose Connection Make sure your plumbing is suitable to install your new dishwasher. If in doubt contact a qualified plumber. Fit the drainage hose of your machine to the drainage pipe without bending. Secure your hose firmly to the waste pipe to avoid it coming off during the washing process. The appliance must be connected to the water mains using the new hose set supplied with your new dishwasher. Old hose sets must not be re-used.
��������� Installation of dishwasher Remove all packaging before positioning the machine. See the following diagram. Ensure there is a clearance each side of the machine to allow slight side ways movement for servicing. Note: If there is already enough space, you don’t need to remove the worktop to install it under the counter. Position the machine next to a water tap and a drain. When inserting the machine, ensure that the water inlet and drain hoses are not linked or squashed.
Make sure your dishwasher is perfectly level using the adjustable feet. When the appliance is correctly levelled, the door will not catch on the inner liner on either side of the cabinet. �� �� If the door does not close correctly, loosen or tighten the adjustable feet, until the machine is perfectly level. 5 How to use Water hardness & regeneration settings The dishwasher requires lime free water. Hard water leaves watermarks on your dishes.
To Adjust the Water Hardness; 1. Press and hold the Programme Selection Key when the machine is off and press On/Off button simultaneously to turn on your machine. Release the Programme Selection Key when the water hardness level stored on your machine is displayed in “r…..” format. 2. Start / Stop icon will start flashing as soon as the water hardness level stored on your machine is displayed in “r…..” format. 3.
Adding Dishwasher Salt Only use special pelletized dishwasher salt in your machine to soften the hard water. Never use other types of salts including table salt, animal feeding salt, sea salt, culinary salt. These types of salt do not dissolve in water easily and will damage your appliance beyond repair. ������ � �� � �� � � ��� When you run the dishwasher, the Water softener will be full of water. Therefore, adding softening salt should always be done immediately before you start the dishwasher.
Warning! Two-in-one and three-in-one detergents You will obtain the best results from your dishwasher if you use separate detergent, rinse aid and watersoftening salt. dishwasher. Always place the tablets in the detergent dispenser of the detergent holder. Detergent manufacturers also produce combined detergents known as ‘two-inone’ and ‘three-in-one’. Three-in-one: These products contain detergent, rinse aid and watersoftening salt.
Using two-in-one detergent and rinse aid • These detergents will not give you the same drying performance that you can obtain by using separate detergent, salt and rinse aid. To increase the drying performance: • Put your appliance’s rinse aid setting at “1” and apply rinse aid. When the rinse aid is used up, add more rinse aid to the rinse aid dispenser.
Detergent residues Regular use of low temperature washes and/or short duration programmes can lead to undissolved detergent residue build up. We recommend to carry out a service wash at the highest temperature possible every 3 - 4 months with the dishwasher empty and without using detergent. It is not recommended to carry it out with auto programme. Position 6: maximum dose.) Gradually increase the dose if there are drops of water or lime spots on the dishes after washing.
Loading the dishwasher Loading the dishwasher correctly will increase the washing, drying and energy performance of your machine. Examine the information given in this section and the information stated in the Programme chart and quick reference card given with the manual. Remove any large scraps of food from the dishes before placing in the dishwasher to avoid clogging the filters. ���������������� � � � There are three separate baskets, in which you can put your dishes.
Folding plate support rods There are two separate “folding plate support rods” in the lower basket of your dishwasher designed to allow you more space to accommodate saucepans and large bowls. You can either fold each section (1,2) individually or, all at once, to create a large empty space.
Upper basket height adjustment The upper basket is equipped with a lifting mechanism which enables you to change the height of the basket even if it is fully loaded, and without having to remove it from the dishwasher. The height of the upper basket was set at the factory to the lowest position. To lift the upper basket to the “high” A position, hold it on one side and carefully pull it upwards. To lift the opposite side of the basket, hold it and pull it upwards in the same manner.
Basket insert with variable height settings You can also use this insert in the lower basket for glasses and longhandled cutlery / utensils. If you do not need the insert, fold the rack upwards at the angle shown (A). Push the entire insert upwards (B). Place the insert in the upright position (C). Push the insert downwards and lock it into place with the holder (D). When you want to use the basket again, reverse the procedure. To set the height, push the rack upwards and fold it open in position (G).
6 Programme Selection and Operating Your Machine Programme Selection Button Start/Pause/Cancel Button Handle Time Delay Button Display Half Load/Combi Tablet Button On / Off Button 10 11 12 13 � 14 10 11 Programme Indicator Salt Indicator Rinse Aid Indicator Remaining Time Indicator / Delay Time Indicator 15 � � 16 12 13 14 15 16 Start Indicator Time Delay Indicator Combi Tablet Indicator Half Load “ ” Indicator Programme Steps Follow-up Indicator a Washing Step Indicator “ ” b Drying Step In
Button and Button Descriptions when the Tablet Detergent function is On / Off Button When you press the On/Off button, the display switches on with the last programme used and it dims when you turn the machine off. If the Half Load, function are enabled during the last programme used, these functions will remain active when the machine is turned off and on again. If you would like to disable these functions after turning the machine off and on again, you must press the relevant buttons. selected.
selecting the desired programme until Combi Tablet Detergent Indicator lights up, then press Start/Pause/Cancel button and close the door of your machine. Time Delay Button You can delay the start of the selected programme until 9 hours with increments of 1 hour by means of the Time Delay Function.
To add a function to the programme: 1. Select the programme by pressing programme selection button. 2. Press the button of the function that you want to enable and check to see a indicator for the relevant function on the display. 3. You can start the programme by pressing the Start / Pause / Cancel button.
If you want to change the programme or functions while the Time Delay function is enabled, then pause the machine by pressing the Start / Pause / Cancel button. You will see that the countdown stops. The Time Delay indicator will start flashing. Select the new programme and/or add the functions as described in Programme Selection and Table of Average Consumption Values. Resume the delayed start countdown by pressing the Start / Pause / Cancel button.
If you switch off the machine with “On/Off” button when the status is “OFF”, then the rinse aid indicator will never come on. Starting Your Machine • Plug the mains plug into the wall • • • • • • • • • • • • machine; be careful. Close the door and press Start/Pause/Cancel button again. Programme will resume running. • • socket. Open the tap. Open the door. Place the dishes. Check if the upper and lower impellers rotate freely.
27 GB Rapid 35 °C Pre-wash - 0,6 Energy (kWh) 30 0,93 / 0,09 0,8 10,4 0,94 10 171 Pre-wash ▼ Wash ▼ Cold rinse ▼ Hot Rinse ▼ Dry ▼ End A+B Medium Most economic programme for normally soiled dishes 50 °C Economy 70 °C Intensive 5 70 °C Hygiene 6 70 °C Active Wash 7 40-65 °C Auto Sensing 8 1,32 10,2 58 Wash ▼ Cold rinse ▼ Hot Rinse ▼ Dry ▼ End A+B Medium 1,26 16,2 143 Pre-wash ▼ Wash ▼ Cold rinse ▼ Hot Rinse ▼ Dry ▼ End A+B High 1,97 17,8 124 Pre-wash ▼ Wash ▼ Cold
7 How to clean your dishwasher Cleaning your machine at regular intervals ensures longer product life and reduces the risk of recurring problems. Clean spray arms and in particular filters at least once a week 2. You can purchase a special micro-fibre cleaning cloth pack called “E-cloth” from your local electrical or hardware store, which is suitable to clean and wipe stainless steel surfaces of kitchen appliances without the need to use any chemicals or other cleaning materials. You just need warm water.
Pull the main filter off. Clean all three filters under running tap water with a brush. Reinsert the main filter in its place. ����������� Place the coarse filter into the micro filter. Ensure the marks align properly. Turn the coarse filter clockwise until you hear a clicking sound. ������������� It is important that you fit the filters correctly. ������������ Caution: the dishwasher must not be used without filters. Incorrect repositioning of the filters will produce poor washing results.
8 Before calling service / Trouble shooting Before calling service check the following & Trouble shooting guide supplied on the following page.
Pitting of stainless steel items Prolonged contact with salty or highly acidic foods or with undissolved or highly concentrated detergent. Remove spots with silver polish. Rewash. Wash soon after use, or pre-wash items if they will not be washed right away. Do not overload cutlery basket. Avoid spilling or pouring detergent directly on flatware. Make sure dispenser cup is properly closed. Improper loading. Load so that all items are properly tilted for good drainage.
• Guarantee for Refrigeration, Cooking Appliances, Washing Machines & Dishwashers. Your new Beko product is guaranteed against the cost of breakdown repairs for one year from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. • The cost of functional replacement parts, but excluding consumable items. • The labour costs of a Beko approved repairer to carry out the repair.
• Before requesting service please check the trouble-shooting guide in the Operating Instructions as a charge may be levied where no fault is found even though your product may still be under guarantee. The product guarantee does not cover damages to plates,glass ware, cutlery, crockery and also damage to the product itself as a result of using these “Three-inone”, “Two-in-one” detergents.
������������������������������������������������������������������ �����������������������������������������������������������������������������������������
