User Guide

6
installation
Adjustable feet
1
2
3
4
5
Fit the two plastic wall spacers supplied with the appliance,
rotating turn to the condenser at the back of the appliance.
Locate the appliance on a smooth surface.
To ensure it is standing upright adjust the two front feet by
turning clockwise or anti-clockwise, until it is in firm contact
with the floor. Correct adjustment of feet avoids excessive
vibration and noise.
A special receptacle is supplied to store the mains plug during
transit. The receptacle is fixed at the back of the cabinet on the
side of the compressor. Gently remove the plug from the
receptacle. Never pull the mains cord, you may damage the
appliance. In case of transportation, ensure you locate the
plug in the receptacle provided to avoid transit damage.
The space in the room where the appliance is installed must
not be smaller than 10 cubic metres.
repositioning the doors (see diagram on the opposite page)
Reposition the plugs on the other side.
Remove the top hinge pin and washer
underneath the front top trim.
Refit the top hinge pin and washer on the
other side.
Refit the fridge compartment door.
Locate middle hinge in door and fit to the
cabinet.
Refit the freezer compartment door.
Refit the bottom hinge on the opposite side.
Refit the adjustable feet and screws.
Carefully stand the appliance upright.
Adjust the feet if necessary.
Replace all loose items and fittings.
Wait for at least 4 hours to allow the system
to settle before switching on.
Spare plastic hinge bushing supplied with the
appliance are for your future use.
9
10
11
12
13
14
15
16
17
18
19
20
Switch off at the socket outlet and pull out
the mains plug.
Remove all food, loose items and fittings.
Carefully lay the appliance on its right hand
side. (You may need somebody to help
you.) Take care not to damage the appliance
by laying on some protective material (e.g.
its original packaging). Make sure that you
lay the appliance on its right hand side,
otherwise compressor oil may block the
pipes and you may damage the appliance.
Unscrew and remove the adjustable feet and
screws from the bottom of the cabinet.
Unscrew the bottom hinge and screws.
Remove the freezer door from the cabinet.
Unscrew the middle hinge from the cabinet
while holding the fridge compartment door
and remove the door carefully.
Reposition the plugs and door hinge
bushings on the opposite side. Remove plugs
with the tip of a small screwdriver.
1
2
3
4
5
6
7
8
OFF
Min. • Max.
1
/
4
Wall spacers
Condenser
Plug receptacle