User Guide

transportation
5
location
The appliance should be transported only in a vertical upright
position. The packing as supplied must be intact during transportation.
If during the course of transport the appliance has to be
transported horizontally, the product must only be laid on its
right hand side (when facing the door front) and it must not be
operated for at least 4 hours to allow the system to settle after
the appliance is brought back to upright position.
Failure to comply with the instructions could result in damage
occurring to the appliance. The manufacturer will not be held
responsible if these instructions are disregarded.
The appliance must be protected against rain, moisture and
other atmospheric influences.
When positioning your appliance take care not to damage your
flooring, pipes, wall coverings etc. Do not move the appliance by
pulling by the door or handle.
Empty any water in the drain tray before moving. See section
‘Defrosting’ and ‘Care & cleaning’ for further information.
Make sure that the defrost water pipe at the back of the product
is fixed to the plastic evaporating pan on the top of the compressor,
to avoid defrost water spillage on the floor.
Important Care must be taken when carrying the appliance
to avoid touching the bottom of the condenser metal
support/pipework at the back of the appliance as you might injure
your fingers and hands or damage your product.
Important Make sure that mains cable is not caught under the
appliance during and after carrying/moving the appliance, to avoid
the mains cable becoming cut or damaged.
Do not attempt to sit or stand on top of your appliance. You
could injure yourself and damage the appliance.
BEKO plc declines to accept any liability should the instructions not
be followed.
Do not put your appliance in a cold room where the temperature
is likely to go below +2 degrees C (36 degrees F) during night time
and/or especially in winter.
This appliance has been designed to operate in room (ambient)
temperatures between +2 and +32 degrees C (36 and 90 degrees
F). Therefore if it is installed in an unheated/cold room (eg conservatory,
annex, shed, garage, etc.) then it will not operate causing the freezer
compartment to run warmer and as a result the storage time of
frozen food may be reduced.
Do not place the appliance near cookers, radiators, or in direct
sunlight as this will cause it to work harder. If installed next to a
source of heat, maintain the following minimum side clearances:
From cookers 50mm (2")
From radiators 300mm (12")
Make sure that sufficient room is provided around the appliance to
ensure free air circulation. We recommend 20mm ( ") clearance
on both sides. The clearance at the back is ensured when the wall
spacers are fitted, see ‘Installation’.
4
/
5