Operating instructions

Control and maintenance
BEKOSPLIT® 11 31
Pos: 123 / Beko Technische D okumentat ion/Wart ung/BEKO S PLIT/War t ung BS11 Reaktionstrennmitt el einfüllen @ 3\m od_131402 114932 9_15098.docx @ 2500 3 @ @ 1
Filling-in the reaction release
agent
Fill the reaction release agent into
the storage reservoir of the dosing
device using the enclosed shovel.
Pos: 124 / Beko Technische D okument ation/Wart ung/BEKO S PLIT/War t ung BS11 Filtersackwechsel @ 4\m od_134336 926351 1_1509 8. docx @ 28552@ @ 1
Replacement of the filter bag
Detach the tension belt and remove the filter.
Put the new filter bag over the inlet extension,
attach the tension belt and then tighten it. The
tension belt must have a tight seat. If this is not
the case, the filter bag may detach itself and
filter cake will emerge.
Dispose of the accumulated filter cake:
European waste disposal key: EWC 070610
Note: the wet weight is significantly higher
than the dry weight. It is recommended to use
a suitable means of transportation.
Pos: 125 / Beko Technische D okument ation/Wart ung/BEKO S PLIT/War t ung BS11 Ölauff angbehälter leeren @ 3\m od_131402138 4719_1 5098.docx @ 25069 @ @ 1
Emptying the oil receiver
Replace the oil receiver by an empty receiver
when the receiver is three quarters full.
Dispose of the accumulated oil as used oil:
European waste disposal key:
EWC 13 02 05 (mineral oils)
EWC 13 02 06 (synthetic oils)