Please read this user manual first! Dear Customer, Thank you for purchasing his Biko product. We hope tat you get te best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefor, please read this entire user manual and all other accompanying documents carefully before using te product and keep its a reference for future use. If yau handover the product 1o someone else, give the user manual as well.
Important instructions and warnings for safety and environment 4 General . Safety when work ri(; Wall qu Electrical safely. Product safe Intended use Safety for children Disposing of the old product Package information : Future Transportation General information 10 Overview Package contents. Technical specific at Inject Heel. Installation Before installation . Installation and connection (Gas conversion Preparation 27 Tips for saving energy .
This section contains safety instructions that will help protect from risk of personal injury or property damage. Failure to follow these instructions shall vied any warranty.
natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood). Prolonged intensive use of the appliance may call for additional ventilation, for example increasing the level of the mechanical ventilation where present. (Gas appliances and systems must be regularly checked for proper functioning. Regulator, hose and its clamp must be checked regularly and replaced within the periods recommended by its manufacturer or when necessary. Clean the gas boomers regularly.
B/EN Never wash the product by spreading or pouring water onto itt There is the risk of electric shock! The product must be disconnected during installation, maintenance, cleaning and repairing procedures. If the power connection cable for the product is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Only use the connection cable specified in the “Technical specifications”.
the sides may become hot during use. During use the appliance becomes hot. Care should be taken to avoid touching heating elements inside the oven. Keep all ventilation slots clear of obstructions. Do not heat closed tins and glass jars in the oven. The pressure that would build-up in the infarct may cause it to burst. Do not place baking trays, dishes aor aluminum foil directly onto the bottom of the oven. The heat accumulation might damage the bottom of the oven.
* NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. Danger of fire: Do not store items on the conking surfaces. CAUTION: The cooking process has to be supervised. A short term caking process has to be supervised continuously. WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shack.
allow them to play with the product. s Do not place any items above the appliance that children may reach for. * When the door is open, do not load any heavy object on it and do not allow children to sit on it. It may overturn or door hinges may get damaged. Disposing of the old product Compliance with the WERE Directive and Disposing of the Waste Product: — This product complies with EU WERE Directive {2012/19/EU).
Package contents Placing the wire shelf and tray onto the accessorizes supplied can vary depending on telescopic racks properly e product model. Nt every accessory (This feature Is optional. It may not exist on described in the User manual ray exist on your product) your product, Telescopic arks aglow you ta install and 1. User manual remove e frays and wire shelf easily. 2. Oven tray When using the tray and wire shelf with Used for pastries, frozen foods and big telescopic racks.
7. Splash back assembly Secure the splash back fo the hob with T ey screws provided. Do nat over tighten the sowers a8 damage to the hob or splash back could coercer, 1 Splash back ® Remove the splash back from the packaging taking care to retain the 5 screws required for fixing the splash back to the hab, Position the splash back as shown.
Technical sons GENERAL. 240\/ 50 Ez 18A Normal Multiplicand oven K s Information on the energy label of electrical gens Is given in accordance with the EN 60360-1/ IEC standard. Those values are determined under standard load with bottom-top heater or fan assisted sang f any) functions. Energy efficiency class is determined in accordance with the following prioritization depending on whether he relevant functions exist on Hie product of not.
This appliance must he installed by an authorized person in accordance with this instruction manual, ASSN 5601 — Gas installations {installation and pipe sizing}.
Electric infer: Rear Sift hand side 860mm from the top and 110 mm from the left towards the canter. » Movement of your appliance is most easily achieved by filing the front as indicated in the drawing. Open the oven door sufficiently 1o allow a comfortable and sags grip on the underside of the oven roof avoid causing any tamale {6 the gill element or any internal parts of the oven, Do not move by pulling on the door handle or knobs.
Before placing the product on furniture; Fix the fixing parts supplied with product with at least two screwed according to the Allowing sizes on BOOR, cabinets and thees Is no clearance requirement 1o adjacent side cabinets, Ash ¢ : the product towards the Kitchen wall like on Place the product by pushing towards the kitchen image below. Before placing, it should be wall. secured with safety chain Pen the bottom cover on the front of the product.
& A 1 Stability hook 2 Locking mechanism 8 Safety chain (supplied and mourned to oven) 4 Firmly fix the tin o cooker rear 5 Hear of cooker 8 Kitchen wall Stability chain to be as short as practicable to avoid oven lifting forward and diagonal to wood oven SIDS tiding.
834 When decorative bottom covers are not used Product height Mining Maxima When decorative hot tam covers are used Min.908 Product height Minsk Max 930 max. 820 T | 651 B11 cashback When decorative bottom covers are not used Product fits height Min.115 Max.170 760 When decorative bot torn covers are used Product fits height Min. 140 Max. 170 min.
Room ventilation Al rams require a b g and some rooms wi permanent vent as wal, The air for combustion is taken from the room air and the exhaust gases are emitted directly into the room. Good room ventilation is essential for safe operation of your appliance, If there is no window or door available for room ventilation, an extra ventilation must be installed The appliance may be located in a kitchen, Kitchen/diner ar a bed-sifting room, butting a room containing & bath or shower.
the poles of this disconnection unit must be adjacent o {not above) the product in accordance with IEE directives. Failure 1o obey this instruction may cause operational problems and invalidate the product warranty. additional protection by a residual current circuit breaker is Recommended. 2. {Open the terminal block cover with a screwdriver. 3. Insert the power cable through the cable clamp below the terminal and secure it 1o the main body with the integrated sower on cable clamping component. 4.
Gas inlay pipe Elbow Gas regulator At the completion of the installation, test far oaks. 22/EN not use Eked Flame to fest for To ensure comet operation of the appliance it is necessary to set e correct surpass for the appliance 1.0kPa for Natural Gag. Hack the pressure by consenting the pressure gauge or canceler to test paint as shown on adjacent figures. Natural Gas: the supplied regulator must be fitted 10 the appliance infer connection. Gas pressure must be adjusted to 1.
Check for correct operation of burners, ignition system etc and demonstrate operation of appliance to customer if burner low setting requires adjustment refer i convention procedure for adjustment. e\ DANGER: Do ot Use open flange or do not smoke. Da not aerate any electrical buttons 8.0, farm bunion, door bell and o Dy rwt uss fixed or mobile prov S Risk of explosion and intoxication! DANGER: . The gas hose must not be clamped, bent or trained of come into intact with hot parts of the product.
Z Control pane! 3 Door The built-in cooling fan cool both the built-n cabinet and the front of the product, sealing tar continues to operate for about 0-30 inmates after the oven is switched if. Gas conversion ANGER: fore starting any work on e gas installation, disconnect the gas supply. There is the risk of explosion! In order to change your appliance's gas type, change all Injectors and make fame adjustment for all valves at reduced flow rate position. Exchange of injector for the burners 1.
5. For the last central, bring the burner both to high-flame and reduced positions and check whether the flame Is on ar off Depending on the type of gas tap used in your appliances the adjustment screw position may 1 Flow rate adjustment screw the gas type of #he unit is changed, then he rating plate that shows the gas type of he unit must also be changed.
I Reparation Tips for saving energy The following information will beep you to use your appliance in an ecological way, and 1o save energy: o Use dark collared or enamel coated cookware In the oven since the heat transmission will be better. * Whigs cooking your dishes, perform & preheating operation if it is advised in the user manual or pooching instructions. * Do not open e door of the oven frequently during cooking. o Try to cook more than one dish in the oven at the same time whenever possible.
Initial heating Heat up the product for about 30 minutes and then switch it off. Thus, any production residues of layers will be burnt off and removed. 5 /ARMING 5 fot surfaces cause burs! traduce may be hot when iris in use. Never Touch e hot boomers, inner sections of e vane, heaters and efc. Keep children away. Always use heat resistant oven gloves when putting in or removing dishes into/from the hot ovens, Electric oven 1. Take all baking trays and the wire grill sut of the oven. 2.
B How touche the fio General information about cooking Sneer 5l the pan with oft more than one thud of if. Dg not leave te hob unattended when hating ofl. Overheated oils bring risk of fire.
Bias shut off safety system (in models with thermionic component} As a curter measure against bio out due fo fluid overflows at boomers, safety mechanism sips and shuts off the gas. * Push the knob Inwards and tum It counter clockwise 1o ignite. * After the gas ignites, keep the knob pressed for 3-5 seconds more to engage the safety system. o ff the gas does not ignite after you press and release the knob, repeat the same procedure hy keeping the knob pressed for 15 seconds.
[ vow cooperate he oven General information on baking, roast mg and grilling ARMING ot surtaxes cause burn! traduce may be hot when iris in use. Never ouch the hot boomers, goner sections of the oven, heaters and e, Keep children away. Always use heat resistant oven gloves when putting in or removing dishes info/from the het oven, Exiting steam can scald your hands, face android ayes. Tms For baking {se Nan-sticky coated appropriate metal plates or aluminum vessels or heat-resistant silicone molds.
» Oven heats up to the adjusted temperature and maintains it, During heating, temperature lamp stays on Switching off the electric oven Tums the function knob and temperature knob to off {upper) position. Rack positions (For models with wire shelf) It is important to place the wire shelf info the sickie rack correctly. Wire sheaf must be inserted between the side racks as illustrated in the figure. Do not let the wire shelf stand against the rear wall of the oven.
Grill+Fan Rifling effect &5 not s strong as in Ful Gil * Outsmart or medium-sized portions in correct shelf position under the grill heater for grilling. + Set the desired temperature.
cooking time you have set. Selected operating mods is activated when the startup teems of rebuking has come and the oven s healed up o the sel temperature. il maintain this temperature until the end of cooking time. » poking time starts o count down on display when cooking starts and all parts of time slice symbol Is fit. The set cooking time s divided into 4 equal parts and when the time of each parts ends, the symbol of that parts tums off.
Changing the time of the day To change the time of the day you have previously set: 1. Touch 3= unit & symbol appears on display. 2. Set the dime of the day with b /e quays 3. The time you have set will be valediction short time, Economy mode You can gave energy with economy mods wheels cooking by setting cooking ime in the oven. This mode completes the cooking with the inner temperature of e oven Dy switching off the heaters before the end of cooking time. Setting the economy mode 1.
have prepared does not exceed the depth of Tips for baking cake the tray. o If the cake is too dry. increase the « |f the upper side of the pasty peels browned, temperature by 10°C and decrease the hut the lower parts nol cooked, make sure cooking time. that the amount of sauce you have sad for » i the cake is wet, use less liquid or lower the pastry is not toa much at fhe bottom of the temperature by 10°C. the pastry.
General information Service fife of the product will extend and the possibility of problems will decrease if the product is cleaned al regular intervals. ¥ ANGER: Disconnect the product farm mains supply fores starting maintenance and cleaning corks. Hers is the risk of electric shook! ANGER: flow the product to cool down before you clean it. Hot surfaces may cause burns! » Clean the product thoroughly after each use.
Catalytic walls {This feature Is optional. it may not exist on your product.} The inner side walls and/or the rear wall (B of yer product may be coated with catalytic enamel. Catalytic walls have a fight mate color and a serous surface. Catalytic walls of the oven should not be cleaned. Parlous surfaces of the catalytic walls are automatically cleaned by adsorbing and converting the spilled oil {slam and carbon dioxide).
1 Neal part 2 Plastic racier 3 Inner slaps pane 4 Lower plastic soot § Fixing foot 6 Window Part of gt Pull the part of glass elder (7} in middies toward yourself (o release the inner glass panels. 8. Pull the inner glass panel 3) towards yourself until it detaches from ifs plastic slots ). 7. Pull Innermost glass panel towards yourself until it detaches from its plastic slots (4) like inner glass panel. 8. When reinstalling the glass panel, make sure that iris seated into the plastic floss.
# your ovens is equipped with & square lamp: 1. Disconnect the product from mains, 2. Remove the wire racks as described. 3. Remove the protective glass cover with a screwdriver, 4. ff your oven lamp is of type (4) shown in the figure helot, remove 1t by rotating as shown and replace type (B, pull and remove it as shown in the figure and replace it. AQUINO 5. Install the glass cover and then the w racks.
>3 This Is nat a fall, operate. » The mains fuse is defective or has tripped, Check fuses in the fuse bax, If necessary, replace or reel therm. » Product is not plugged into the {grounded) socket. Check the plug connection. o Buttonsknabs/keys on the control panel do not function. Locke may be enabled. Please saber . (Sec. Using e locket. ) o Avon lamp is defective. Replace oven lamp. o Powers cut > Check I there is power. Check the fuses in the fuse box.
