Technical data

Scope of delivery
Data Display DD109 17
14.5.2 Alarm settings
It is possible to set 2 individual alarm thresholds:
1. “Set Alarm 1 threshold”
2. ”Set Alarm 2 threshold”
In this example the sensor is connected to terminal I.
„Type: High" means:
T
he alarm is triggered if the value is higher than the threshold.
If the alarm is exceeded or dropped below the background
becomes red resp. starts blinking.
The factory setting of the hysteresis is 35°F td.
Please observe that these adjustments cannot be changed directly
in the Data Display.
Please turn to BEKO TECHNOLOGIES GMBH
14.5.3 Sensor settings
Sensor settings for our consumption or dew point sensors are stored within the sensor itself. The Data
Display can be used in order to change those settings. For this purpose, select in the menu the function
“Sensor settings”. On the next screen the available inputs are shown: e. g.
Terminal I: Dew point
Terminal G: Consumption
Select the desired entry mask in order to carry out the sensor settings.
If a sensor is connected to a switched on Data Display, the configuration of the Data Display will be
transferred to the sensor without any prior query. (e.g. analogue output, diameter for consumption probes …)
On delivery of a unit Data Display/sensor the adjustments are matched. Please check the coordination if you
connect sensors with deviant adjustments to the Data Display.
14.5.4 System status and settings
Setup time/date Set the integrated clock.
Show system status This screen contains important information for service enquiries.
Change LCD contrast Contrast of the display can be changed.
System reset
In case other sensors are connected it is recommended to use this
function in order to update the system settings.
15 Scope of delivery
• Data Display in wall housing according to your order
• Fastening clips for panel mounting
• Instruction manual