Dishwasher Instruction Manual
Dear customer, Please read carefully right through this instruction booklet before installing or operating your dishwasher. The following instructions should prevent the risk of personal injury and/or damage to the appliance. Please keep these documents in a safe place for later reference. This operating manual has been written for several different machines, and some of the features mentioned here may not apply to your particular model.
TABLE OF CONTENTS 1 Getting To Know Your Machine 3 View of the Machine Technical Specifications 3 4 2 Safety Instructions 4 Before Installation Before First Use Child Safety For daily operation Problems What should not be washed in your dishwasher 3 Directions for Assembly Safety notes for installation Installing Your Dishwasher Water connection Connect water inlet hose Water drainage Electrical connection Disposal 4 Using Your Dishwasher Filling the dishwasher salt When operating for the first time
1 Getting To Know Your Machine View of the Machine �� � � � �� � �� � � � � � �� 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
Technical Specifications Permitted water pressure: 0,3 –10 bar (= 3 – 100 N/cm² = 0,01-1,0Mpa) Electrical connection: 220-240 Volts, 10 Amps (see type plate) Output: 1900-2200 W Heat output: 1800 W This device corresponds to the following EU directives: 2006/95/EC: Low Voltage Directive 2004/108/EC: EMV Directive DIN EN 50242: Electrical dishwasher for home use Testing procedures for practical service conditions Because we continually strive to improve our products, we may change our specifications and de
• • • manufacturers of the detergents. Never leave children unsupervised while the appliance is open, as the appliance may still contain detergent leftovers. The water in the dishwasher is not drinking water. Danger of caustic injuries. Always place long and sharp/ pointed objects (e.g. serving forks, bread knives) into the cutlery basket with the pointed end down or flat on the upper basket to avoid possible injuries.
3 Directions for Assembly Safety notes for installation Installing Your Dishwasher • Choose a suitable location for your Prior to installing and using your appliance, please check it for possible transit damage. • If the appliance is damaged, please contact your supplier. Never install or use a damaged appliance. • The following directions must be followed to connect the dishwasher properly.
Water connection • There are two different types of water inlet hoses: - Cold water inlet hose (up to 25°C) - Hot water inlet hose (up to 60°C)please check which one is applicable to your model. • If you are willing to connect your machine to natural energy resources or to the central hot water supply, first check out whether your water inlet hose type is suitable by checking the temperature values written on the hose. If your hose is not suitable, apply to your authorized service to change the hose.
Water drainage Connecting the drainage hose. Take care to ensure that the drainage hose is not bent or squeezed. 1011 ��� �� Siphon connection The drainage height must be between 50 and 100cm above the floor. �� �� � �� �� �� �� ������� �� ��������� The maximum length must not exceed 4m. Using a longer hose will produce poorer cleaning results. Use hose clamps to fasten the drainage hose to the siphon. �� ���� ���������� ��� Check that the drainage hose is firmly seated.
Warning Packaging materials may be dangerous to children.Reusable substances may be dropped off at your local disposal facilities. You may obtain further information from your local authorities and disposal facilities. the product, it’s packaging or in the manual. Materials used are recyclable according to their labelling. Reuse, recycling of materials and further reutilization of used products are important contributions to protect our environment.
When operating for the first time: � Pour 1 litre of water into the salt container (Fig. C). Pour the salt into the container with the aid of the salt funnel provided (Fig. D). Pour in enough salt to fill the container. The container holds approx. 2 kg. To speed up the rate of dissolution of salt in water, stir it with a spoon. � Close the cap tightly. Begin a washing program immediately after filling the salt container.
Filling the Rinse Aid Dispenser Rinse aids allow washing water to rinse off more cleanly and prevent watermarks or streaks on the dishes. Only use rinse aid designed for use in dishwashers. Note If you use “2 in 1” or “3 in 1“ detergents / tablets, you do not need an additional rinse aid. 1013 � Open the rinse aid dispenser by pressing the locking lever (B) � Carefully pour in rinse aid to the MAX mark. Close the lid until it clicks (3). Carefully wipe off spilled rinse aid.
When the dishwasher is fully loaded and the dishes are very dirty, we recommend filling the detergent container up to the 25 cm³ mark. When the dishes are less dirty, it is generally sufficient to fill the detergent up to the 15 cm³ mark. If your dishes have been in the dishwasher for some time without being washed, you should also fill the small detergent container up to the line (2). Please use detergents produced specially for the dishwashers in your machine.
Multipurpose Detergents Make sure that salt and rinse aid compartments are full. The best washing results in dishwashers is obtained by using detergent, rinse aid and water softening salt individually. Set the water hardness to its highest degree and perform an empty run. New products of the detergent producers what they call as “Multipurpose Detergent” can act as water softening salt and/or rinse aid in addition to acting as a detergent.
Attention Knives and other utensils with sharp tips and edges must be placed horizontally into the upper basket due to risk of injury. Please do not overload your dishwasher and pay attention to the notes regarding dishes which are suited to the dishwasher. Only in this manner will you obtain optimal washing results with a sensible use of energy.
2 folding plate support rods (depending on the model) There are four separate “folding plate support rods” in the lower basket of your dishwasher designed to allow you more space to accommodate saucepans and large bowls in the lower basket. You can either fold each section (1, 2) individually or, all at once, to create a large empty space. Simply press the handgrips (A) and fold them down” � � 1054 � Bottle holder (depends on some models) For cleaning your bottles.
Variable cutlery basket (depending on the model) The variable cutlery basket can be separated into 3 parts depending on the amount of cutlery and the degree of dirtiness. Small cutlery basket sections also fit into the upper basket. To do this, turn the lock on the handle to the right (A). � Pull the smaller cutlery basket upwards and out of its holders (B). To put the parts together again, proceed in the opposite direction.
Basket insert with variable height settings (depending on some models) You can also use this insert in the lower basket for glasses and longhandled cutlery / utensils. If you do not need the insert, fold the rack upwards at the angle shown (A). Push the entire insert upwards (B). Place the insert in the upright position (C). Push the insert downwards and lock it into place with the holder (D). 1019 When you want to use the basket again, reverse the procedure.
Loading suggestions Load the upper basket with dessert plates, cups, glasses etc. 1027 Upper basket with variable height setting (depends on some models) The upper basket is equipped with a lifting mechanism which enables you to change the height of the basket without having to remove it from the dishwasher, even if it is fully loaded. 1021 The height of the upper basket was set to its lowest position at the factory.
Height setting with empty basket (depends on the model) In this model, the height setting of the upper basket may be changed using the wheels which are mounted at two different heights. Release the latches on both the right and left tracks of the upper basket by pushing them outwards (C). � 1022 Pull out the basket out completely (D). Place the basket back into the tracks at the desired height (E). Push the latches back into the correct position.
Glass Support (depends on the model) When placing the glasses or goblets with a long grip, lean them against the glass support, the edge of the basket or the shelf but not against the other pieces. Do not lean the long glasses against each other, otherwise they do not remain stable during washing cycle and may get damaged. 1025 When you need to place the bulky pieces into the upper basket, disconnect the lug of the glass support from the bar of the basket where it is attached to.
5 Program Selection and Operating Your Machine �� � � � � � � � �� �� �� � � � � �� �� �� � � �� 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. On / Off Button Combi Tablet Button Program Selection Button Half Load Button Display Start/Pause/Cancel Button Delayed Start Button Combi Tablet Indicator light Handle Program Indicator Remaining Time Indicator/Delay Time Indicator 12. 13. 14. 15. 16. 17.
Button and Button Descriptions programs can change depending on the model you have purchased. On / Off Button (1) When you press the On/Off button, the display switches on with the last program used and it dims when you turn the machine off. If the Half Load (4), Extra Drying (5), Child Lock (16), Combi Tablet (2) and Delayed Start (13) functions are enabled during the last program used, these functions will remain active when the machine is turned off and on again.
Delayed Start Button (8) You can delay the start of the selected program until 24 hours with increments of 1 hour by means of the Delayed Start Function. Program Selection You can select the desired program after turning on the machine by pressing the On / Off button (1). Switch to the program you want to operate by pressing program selection button (3). You can follow up the program you are in from the program indicator (11) on the screen.
lighting continuously when the program cancellation is completed. You may select and operate a new program following the program cancellation process. There might be residues of detergent or rinse aid left in the machine and/or on the pieces being washed depending on the step the previous program was in at the time of such cancellation. Changing a Program Press Start / Pause / Cancel button (7) first to switch your machine into pause mode if you want to change your selection after you started the program.
If you want to select a new delayed start time while the delayed start countdown is in progress, then pause the machine by pressing the Start / Pause / Cancel button (7). Set the desired time by pressing the Delayed Start Button (8). Start the countdown for the new time by pressing the Start / Pause / Cancel button (7) again. Usage of Child Lock Press the Child Lock buttons ((3) and (4) simultaneously for three seconds in order to activate the child lock.
• Starting Your Machine • Plug the mains plug into the wall • • • • • • • • • • • • socket. Open the tap. Open the door. Place the dishes. Check if the upper and lower impellers rotate freely. Put sufficient amount of detergent in the detergent dispenser and close its lid. Press On/Off button. Check if the salt and rinse aid warning indicators (17,18) light and add salt and/or rinse aid if needed. Determine your washing program with the aid of the Program Data and Table of Average Consumption Values.
27 GB 1 2 35 °C Mini 30' 35°C wash ▼ Cold rinse ▼ Hot Rinse ▼ End Pre-wash ▼ End 0,5 Energy (kWh) 4 65 °C Quick & Clean + 0,75 10,2 + 1,05 13 155 Pre-wash ▼ 50 °C Wash ▼ Cold rinse ▼ Hot Rinse ▼ Dry ▼ End A+B Medium + 1,24 10,2 58 65°C Wash ▼ Cold rinse ▼ Hot Rinse ▼ Drying ▼ End A+B Medium 5 + 1,45 14,8 136 40°C Prewash ▼ 70°C Wash ▼ Cold rinse ▼ Hot Rinse ▼ Dry ▼ End A+B High Heavily soiled dirty dishes with dried-on food leftovers 70 °C Intensive The consumption valu
6 How to clean your dishwasher Cleaning your machine at regular intervals ensures longer product life and reduces the risk of reccurring problems. Warning Always unplug the machine and turn off the water supply before cleaning. Use a gentle household cleaner for the outside and the door seals. Clean the control panel only with a moist cloth and clear water. Warning Do not operate your dishwasher without a filter. Ensure that your filters are correctly installed. Clean the filters regularly.
Cleaning the spray arms Dirt or calcium residue may block the nozzles on the spray arms. For this reason, regularly check the spray nozzles. Cleaning the filter inset in the water inlet hose (depending on the model) Dirt from deposits in the water pipes is prevented by a filter in the water inlet hose. Check the filter and the water inlet from time to time. 1. 2. Lower spray arm Upper spray arm 1. 1. Remove the lower basket from the machine. Pull off the lower spray arm in an upward direction (A).
7 Troubleshooting: What to do if the dishwasher will not run • Check that the mains plug is properly connected. • Are all fuses working? • Is the water supply fully turned on? • Is the dishwasher door closed firmly? • Have you pressed the On/Off button? • Is the filter on the water intake and dishwasher clogged? The cleaning results are unsatisfactory 1033 Uncleaned Dishes Disorderly placement - Load your dishes as described in the manual.
Inadequate rinse aid - Increase rinse aid setting or add rinse aid into rinse aid compartment. Unsealed detergent dispenser lid - Always ensure that the detergent compartment lid is closed tightly after every detergent filling process. Drying Disorderly placement - Load your dishes as described in the manual. Inadequate rinse aid - Increase rinse aid setting or add rinse aid into rinse aid compartment.
1035 Lime Stains, Hazy Look Inadequate rinse aid - Increase rinse aid setting or add rinse aid into rinse aid compartment. Insufficient water softening - In products equipped with water softening setting, water softening should be properly set in accordance with the hardness of the supply water. Add salt into the salt container, if necessary. Salt leakage* - Use the supplied salt funnel while filling in softening salt. Make sure that the salt box cover is tightly closed after finishing the filling process.
1041 Scratch / Break In Glassware Kitchenware containing Aluminum - Kitchenware that contains aluminum should not be washed in dishwashers. Salt leakage* - Use the supplied salt funnel while filling in softening salt. Make sure that the salt box cover is tightly closed after finishing the filling process. Run a washing program to clean up the salts spilled in the machine. Recheck the salt box cover after the program is completed.
1038 Detergent Remains In The Detergent Dispenser Damp detergent compartment - Make sure that the detergent dispenser is well dried prior to filling it with detergent. Putting detergent in the detergent dispenser long before washing - Take care that detergent is put shortly before startup of washing.
Leaving the dishes in the dishwasher for a long time - If you are not going to run your dishwasher immediately, load the dishes into your machine after scraping the excessive soil on them and do not tightly close the door of the machine. Every other day, perform washing without detergent in the shortest program for products with program selecting feature. 1042 Foam Loading the dishes into the dishwasher without completely drying after washing them with hand-wash detergent.
Service If your appliance ever malfunctions, check the notes and advice given in the operating manual. If this does not fix the problem, our customer service staff are available to assist you.
GB 17 1577 0100-03
