Operation Manual

8
Changing the oil
1. Put a reservoir below the pedals
shell to collect the oil. Take o
the Allen bolt form the boom
side of the bracket shell and let
the oil pour out.
2. When the bracket shell is empty
put the bike up side down and
insert some cleaning uid in the
bracket shell. This can be diesel
or turpenne. Turn round the
pedals for about three minutes
in order to clean the gears.
3. Put the bike back on it’s wheels
carefully and let the uid pour
out in the reservoir. You can
repeat this step if you think
there is sll dirt inside.
4. Put the bike up side down again
and insert 50 ml oil in the
bracket shell. The oil is included
in the beixo sha drive
maintenance kit. Tighten the
Allen bolt again and the bike is
ready for use again.
Important: Do not open the sha drive
system yourself. This will void your war-
ranty.
Cleaning your bike
By keeping your beixo clean, you’ll enjoy
it much longer. First use a so brush to
remove the dirt. Next go to work with
warm water mixed with a mild liquid soap
and a so coon cloth.
In case of rim-brakes it’s important to
keep the rims free from salt or sand in
the winter period. Clean rims last much
longer.
Allen bolt
Tires
It is impossible to make a general rec-
ommendaon on inaon pressure for
a specic bicycle or a parcular re. The
“right” inaon pressure depends mainly
on the load exerted on the re. The per-
mied inaon pressure range is marked
on the re sidewall. Make sure the actual
re pressures never is higher or lower
than the maximum and minimum ina-
on pressures.