Technical data

About this operating manual
Operating manual 100-69 version 00.0 - 05/2013
4
1.3 Conventions of representation– Symbols and characters
Different information is depicted or highlighted in this operating manual by
the following characters for easier and quicker understanding:
Safety Important warnings for the user of the machine are specifically marked.
Because safety constitutes an area of major importance, hazard symbols,
levels of risk, and their signal words are described separately in  chap-
ter 3 of the Safety Instructions.
Location
information
Information on where something is positioned using the terms "right" or
"left" must always be regarded from the operator's point of view if the fig-
ure gives no other obvious indication for determining the location.
1.4 Other documents
The device contains built-in components from other manufacturers. The
respective manufacturers have carried out hazard assessments for these
purchased parts and confirmed compliance of the design with the applica-
ble European and national regulations. The intended use of the built-in
components is described in the corresponding manuals of the manufac-
turers.
1.5 Liability
All information and notes in this operating manual have been compiled in
accordance with the latest technology and the applicable standards and
regulations.
The manufacturer cannot be held liable for any damage due to:
• Damage during transport
• Failure to observe the operating manual
• Improper use
• Unauthorized modifications to the machine
• The deployment of untrained personnel
• Using spare parts not approved
Symbol/character Meaning
•
Lists are identified by bullet points.
1.
2.
Instructions are numbered and have to be performed in the
specified order.

References to further information in this operating manual or
other documents are identified by this symbol.